LT1102

5

1102fb

ELECTRICAL CHARACTERISTICS

Note 1: Stresses beyond those listed under Absolute Maximum Ratings

may cause permanent damage to the device. Exposure to any Absolute

Maximum Rating condition for extended periods may affect device

reliability and lifetime.

Note 2: This parameter is tested on a sample basis only.

Note 3: Current noise is calculated from the formula:

Ω

swamps the contribution of current noise.

Note 4: This parameter is not tested. It is guaranteed by design and by

inference from the slew rate measurement.

Note 5: Overdrive recovery is defined as the time delay from the removal

of an input overdrive to the output’s return from saturation to linear

operation.

Note 6: This parameter is not tested. It is guaranteed by design and by

inference from other tests.

TYPICAL PERFOR A CE CHARACTERISTICS

Small Signal Response, G = 10

(Input = 50mV Pulse)

Small Signal Response, G = 100

(Input = 5mV Pulse)

Slew Rate, G = 100

(Input =

±130mV Pulse)

Settling Time, G = 10

(Input From – 10V to 10V)

Settling Time, G = 10

(Input From 10V to –10V)

Settling Time, G = 100

(Input From – 10V to 10V)

2

μS/DIV

2

μS/DIV

2

μS/DIV

2

μS/DIV

1

μS/DIV

1

μS/DIV

2

μS/DIV

Settling Time, G = 100

(Input From 10V to –10V)