1. TINT is the line-scan rate or integration time. It is determined by time interval between

two start pulses, SP. Hence, if SP is generated from a clock count down circuit, it will be

directly proportional to clock frequency. And it will be synchronous with the clock

frequency. The longest integration time is determined by the degree of leakage current

degradation that can be tolerated by the system. A 10ms maximum is a typical rule-of-

thumb. An experienced CIS user can use his discretion and determine the desired

tolerance level for the given system.

2. FREQ is clock frequency, also equal to the signal data rate. It is generally fixed for

many applications for following reasons: One is the exposure time. With a give light

power, the exposure time of the sensor depends on integration time and in most

applications it uses clock count down circuits to generate the SP, shift register start

pulse. The second is the shape of the video output pulse. Because of the output is in

pulse packets of video charges, the signal are processed on the output video line of the

sensors. The signal shape depends greatly upon the amplifier configurations. Please

refer to the referenced PI3039 Data Sheet. It has some brief outline application notes.

Under Note 6 in page 6 there is a discussion on video pulse shapes. On page 8, 9 and

10 there are discussions on the three types of signal output stages.

3. The RESPONSIVITY is the ratio of video signal in volts divided by the unit exposure

to 1.27V. The spread of the measured exposure R-RSP, G-RSP and B-RSP can be

used to compute the user’s desired signal voltage level.

Since this is prototype module, all of the following notes 4, 5, 6, 7 and 8, are on data, based on

engineering scope measurements, the data will be re-measured during pilot production using all

the standard QA practices under the control of ISO 9000 regulations. Furthermore, they will be

taken on fully computerized test systems. If required, these prototype data may be revised.

4. Vpmax = maximum pixel value of Vp(n); Vpmin = minimum pixel value of Vp(n); Vpavg =

å

uniform white target. Vp values are measured with a uniform exposure.

5. BRIGHT OUTPUT NONUNIFORMITY: Up(+) = [(Vpmax - Vpavg) / Vpavg] x 100% or

Up(-)= [(Vpavg - Vpmin) / Vpavg] x 100%, whichever polarity with the highest value is

selected. Two further notes, one is that the PI616MC-AS has no requirement for an

optical system, or a light system. The second is that the non-uniformity is dominated by

the LED light bar’s non-uniformity so only the sensor non-uniformity is specified. The

normal standard CIS modules are enclosed in a self-contained module with the

complete optical and LED lighting system. So the light system, usually LED bar, is

included in making the measurement of the optical characteristics. This fixes the optical

geometry for the module and the light source. So the module’s optical characteristics

are simply measured with the module placed on a uniform reflecting target with a know

reflection density. However, the PI616MC-AS is not enclosed with its optical and light

source system. So Up is measured with uniform light source that directly illuminates the

image sensors’ photosite.

6. ADJACENT PIXEL NONUNIFORMITY: Upadj = MAX[ | (Vp(n) - Vp(n+l) | / Vp(n)] x

100%. Upadj is non-uniformity in percentage of Vpavg. It is the maximum difference

amplitude between two neighboring pixels.

7. BRIGHT OUTPUT TOTAL NONUNIFORMITY: Uptotal = [Vpmax -Vpmin]/Vpavg

8. DARK NONUNIFORMITY: Ud = Vdmax – Vdmin: It is measured over the full length of

the array with the light source off and the sensors are placed in the dark. Vdmax is the

maximum pixel value of the video pixel with the exposure off. Vdmin is the minimum

Notes:

PAGE 6 OF 22 - PI616MC-AS, 12/20/02