24C01B/02B

DS21233B-page 4

Preliminary

 2004 Microchip Technology Inc.

2.0

FUNCTIONAL DESCRIPTION

The 24C01B/02B supports a bi-directional two wire bus

and data transmission protocol. A device that sends

data onto the bus is defined as transmitter, and a

device receiving data as receiver. The bus has to be

controlled by a master device which generates the

serial clock (SCL), controls the bus access, and gener-

ates the START and STOP conditions, while the

24C01B/02B works as slave. Both master and slave

can operate as transmitter or receiver but the master

device determines which mode is activated.

3.0

BUS CHARACTERISTICS

The following bus protocol has been defined:

• Data transfer may be initiated only when the bus

is not busy.

• During data transfer, the data line must remain

stable whenever the clock line is HIGH. Changes

in the data line while the clock line is HIGH will be

interpreted as a START or STOP condition.

Accordingly, the following bus conditions have been

defined (Figure 3-1).

3.1

Bus Not Busy (A)

Both data and clock lines remain HIGH.

3.2

Start Data Transfer (B)

A HIGH to LOW transition of the SDA line while the

clock (SCL) is HIGH determines a START condition.

All commands must be preceded by a START condi-

tion.

3.3

Stop Data Transfer (C)

A LOW to HIGH transition of the SDA line while the

clock (SCL) is HIGH determines a STOP condition. All

operations must be ended with a STOP condition.

3.4

Data Valid (D)

The state of the data line represents valid data when,

after a START condition, the data line is stable for the

duration of the HIGH period of the clock signal.

The data on the line must be changed during the LOW

period of the clock signal. There is one clock pulse per

bit of data.

Each data transfer is initiated with a START condition

and terminated with a STOP condition. The number of

the data bytes transferred between the START and

STOP conditions is determined by the master device

and is theoretically unlimited, although only the last six-

teen will be stored when doing a write operation. When

an overwrite does occur it will replace data in a first in

first out fashion.

3.5

Acknowledge

Each receiving device, when addressed, is obliged to

generate an acknowledge after the reception of each

byte. The master device must generate an extra clock

pulse which is associated with this acknowledge bit.

The device that acknowledges has to pull down the

SDA line during the acknowledge clock pulse in such a

FIGURE 3-1:

DATA TRANSFER SEQUENCE ON THE SERIAL BUS

Note:

The 24C01B/02B does not generate any

acknowledge bits if an internal program-

ming cycle is in progress.

SCL

SDA

(B)

(D)

(D)

(C)

START

CONDITION

ADDRESS OR

ACKNOWLEDGE

VALID

DATA

ALLOWED

TO CHANGE

STOP

CONDITION