STR. The STR is an 8-bit status register which stores

count related status information.

CY

BW

CMP

IDX

CEN

PLS

U/D

S

7

6

5

4

3

2

1

0

7366R-122205-3

IR. The IR is an 8-bit register that fetches instruction bytes from

the received data stream and executes them to perform such

functions as setting up the operating mode for the chip (load the

MDR) and data transfer among the various registers.

B7

B6

B5

B4

B3

B2

B1

B0

B2 B1 B0 = XXX (Don’t care)

B5 B4 B3 = 000: Select none

= 001: Select MDR0

= 010: Select MDR1

= 011: Select DTR

= 100: Select CNTR

= 101: Select OTR

= 110: Select STR

= 111: Select none

B7 B6 = 00: CLR register

= 01: RD register

= 10: WR register

= 11: LOAD register

The actions of the four functions, CLR, RD, WR and LOAD are elaborated in Table 1.

TABLE 1

Number of Bytes

OP Code

Register

Operation

MDR0

Clear MDR0 to zero

MRD1

Clear MDR1 to zero

1

CLR

DTR

None

CNTR

Clear CNTR to zero

OTR

None

STR

Clear STR to zero

MDR0

Output MDR0 serially on TXD (MISO)

MDR1

Output MDR1 serially on TXD (MISO)

2 to 5

RD

DTR

None

CNTR

Transfer CNTR to OTR, then output OTR serially

on TXD (MISO)

OTR

Output OTR serially on TXD (MISO)

STR

Output STR serially on TXD (MISO)

MDR0

Write serial data at RXD (MOSI) into MDR0

MDR1

Write serial data at RXD (MOSI) into MDR1

2 to 5

WR

DTR

Write serial data at RXD (MOSI) into DTR

CNTR

None

OTR

None

STR

None

MDR0

None

MDR1

None

1

LOAD

DTR

None

CNTR

Transfer DTR to CNTR in “parallel”

OTR

Transfer CNTR to OTR in “parallel”

CNTR. The CNTR is a software configurable 8, 16, 24 or 32-bit up/down counter which counts the up/down pulses resulting from

the quadrature clocks applied at the A and B inputs, or alternatively, in non-quadrature mode, pulses applied at the A input.

By means of IR intructions the CNTR can be cleared, loaded from the DTR or in turn, can be transferred into the OTR.

OTR. The OTR is a software configuration 8, 16, 24 or 32-bit register which can be read back on the MISO output.

Since instantaneous CNTR value is often needed to be read while the CNTR continues to count, the OTR serves as a

convenient dump site for instantaneous CNTR data which can then be read without interfering with the counting process.

CY: Carry (CNTR overflow) latch

BW: Borrow (CNTR underflow) latch

CMP: Compare (CNTR = DTR) latch

IDX: Index latch

CEN: Count enable status: 0: counting disabled,

1: counting enabled

PLS: Power loss indicator latch; set upon power up

U/D: Count direction indicator: 0: count down, 1: count up

S: Sign bit. 1: negative, 0: positive