www.ti.com

t − Time − 10 ms/div

PTH12030W/L

SLTS211F – MAY 2003 – REVISED FEBRUARY 2007

CONDITIONS FOR PREBIAS HOLDOFF

In order for the module to allow an output prebias voltage to exist (and not sink current), certain conditions must

be maintained. The module holds off a prebias voltage when the Inhibit pin is held low, and whenver the output

is allowed to rise under soft-start control. Power up under soft-start control occurs upon the removal of the

ground signal to the Inhibit pin (with input voltage applied), or when input power is applied with Auto-Track

its Inhibit), the input voltage must always be greater than the applied prebias source. This condition must exist

The soft-start period is complete when the output begins rising above the prebias voltage. Once it is complete,

the module functions as normal, and sinks current if voltage higher than the nominal regulation value is applied

to its output.

Note:If a prebias condition is not present, the soft-start period is complete when the output voltage has risen

to either the set-point voltage, or the voltage applied at the module’s Track control pin, whichever is lowest.

DEMONSTRATION CIRCUIT

the prebias voltage, which is passed from the VCCIO to the VCORE voltage rail through the ASIC. Note that the

prebias.

Figure 18. Prebias Startup Waveforms

NOTES

1. Output prebias holdoff is an inherent feature to all PTH120x0L and PTV120x0W/L modules. It has now

been incorporated into all modules (including W-suffix modules with part numbers of the form

PTH120x0W), with a production lot date code of 0423 or later.

2. The prebias start-up feature is not compatible with Auto-Track. If the rise in the output is limited by the

voltage applied to the Track control pin, the output sinks current during the period that the track control

voltage is below that of the back-feeding source. For this reason, it is recommended that Auto-Track be

disabled when not being used. This is accomplished by connecting the Track pin to the input voltage, V

This raises the Track pin voltage well above the set-point voltage prior to the module’s start up, thereby

defeating the Auto-Track feature.

3. To further ensure that the regulator’s output does not sink current when power is first applied (even with a

ground signal applied to the Inhibit control pin), the input voltage must always be greater than the applied

prebias source. This condition must exist throughout the power-up sequence of the power system.

18

Submit Documentation Feedback