M95128-RMB3GSLASHP datasheet(43/44 Pages) STMICROELECTRONICS

43 / 44 page

M95128, M95128-W, M95128-R

Revision history

43/44

13-Apr-2006

New M95128 datasheet extracted from the M95128/256 datasheet. Order

of sections modified.

ECC (error correction code) and Write cycling paragraph added.

Section 3.7: Supply voltage (VCC) added and information removed below

Section 4: Operating features.

Power up state removed below Section 6: Delivery state.

Figure 13: SPI modes supported modified and Note 2 added.

ICC1 specified over the whole VCC range and ICC0 added to Table 13,

Table 14 and Table 15.

ICC specified over the whole VCC range in Table 13.

tCHHL and tCHHH replaced by tCLHL and tCLHH, respectively.

Figure 16: Hold timing modified.

Process letter and Note 1 added to Table 23: Ordering information

scheme.

“AC Characteristics (M95128, Device Grade 6)” Table (for 10MHz

frequency) removed.

Note 1 removed from Table 19: AC characteristics (M95128-R).

TA added to Table 6: Absolute maximum ratings.

PDIP8 (BN) and SO8 wide (MW) packages removed. M95128-W and

M95128-R are no longer under development.

Test conditions changed for VOL and VOH in Section Table 14.: DC

characteristics (M95128-W, device grade 3).

27-Jun-2006

Figure 12: Bus master and memory devices on the SPI bus modified.

SO8N package specifications updated (see Table 20 and Figure 18).

V Process specified and A Process replaced by P in Table 23: Ordering

information scheme.

04-Oct-2007

Section 3.7: Supply voltage (VCC), Section 4.3: Data Protection and

protocol control, Section 5.4: Write Status Register (WRSR), Section 5.6:

Write to Memory Array (WRITE) and Section 5.6.1: ECC (error correction

code) and Write cycling updated.

Note removed below Figure 12: Bus master and memory devices on the

SPI bus, replaced by paragraph.

Test conditions modified for ICC1 and ICC0 in Table 15: DC characteristics

(M95128-R). AC characteristics values added for fC frequency = 10 MHz in

Table 16: AC characteristics (M95128, device grade 3).

tW modified in Table 19: AC characteristics (M95128-R).

Section 10: Package mechanical:

– UFDFPN8 package added

– Package mechanical inch values calculated from mm and rounded to 4

decimal digits

Table 24: Available M95128x products (package, voltage range,

temperature grade) added.

Blank removed below Plating technology, first note removed, process A

added and process V removed in Table 23: Ordering information scheme.

Table 25.

Document revision history (continued)

Date

Revision

Changes

M95128-RMB3G/P 数据表(PDF) 43 Page - STMicroelectronics

M95128-RMB3G/P 数据表(HTML) 43 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

数据表下载