M95M01-RMW6P datasheet(27/39 Pages) STMICROELECTRONICS

27 / 39 page

M95M01-R

ECC (error correction code) and write cycling

27/39

ECC (error correction code) and write cycling

The M95M01-R device offers an ECC (Error Correction Code) logic which compares each

4-byte word with its associated 6 EEPROM bits of ECC. As a result, if a single bit out of 4

bytes of data happens to be erroneous during a Read operation, the ECC detects it and

replaces it by the correct value. The read reliability is therefore much improved by the use of

this feature.

Note however that even if a single byte has to be written, 4 bytes are internally modified

(plus the ECC bits), that is, the addressed byte is cycled together with the other three bytes

making up the word. It is therefore recommended to write by words of 4 bytes in order to

benefit from the larger amount of Write cycles.

The M95M01-R device is qualified at 1 million (1 000 000) Write cycles, using a cycling

routine that writes to the device by multiples of 4-byte packets.

Power-up and delivery state

8.1

Power-up state

After Power-up, the device is in the following state:

●

Standby Power mode

●

Deselected (after Power-up, a falling edge is required on Chip Select (S) before any

instructions can be started).

●

Not in the Hold Condition

●

Write Enable Latch (WEL) is reset to 0

●

Write In Progress (WIP) is reset to 0

The SRWD, BP1 and BP0 bits of the Status Register are unchanged from the previous

power-down (they are non-volatile bits).

8.2

Initial delivery state

The device is delivered with the memory array set at all 1s (FFh). The Status Register Write

Disable (SRWD) and Block Protect (BP1 and BP0) bits are initialized to 0.

M95M01-RMW6P 数据表(PDF) 27 Page - STMicroelectronics

M95M01-RMW6P 数据表(HTML) 27 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

数据表下载