TLP705

2007-10-01

2

Characteristics

Symbol

Rating

Unit

Forward current

20

mA

Forward current derating (Ta ≥ 85°C)

−0.54

mA/°C

Peak transient forward current

(Note 1)

1

A

Reverse voltage

5

V

Junction temperature

125

°C

“H” peak output current

(Note 2)

−0.45

A

“L” peak output current

(Note 2)

0.45

A

Output voltage

25

V

Supply voltage

25

V

Junction temperature

125

°C

Operating frequency

(Note 3)

f

250

kHz

Storage temperature range

−55 to 125

°C

Operating temperature range

−40 to 100

°C

Lead soldering temperature (10 s)

(Note 4)

260

°C

Isolation voltage (AC, 1 minute, R.H. ≤ 60%)

(Note 5)

5000

Vr m s

Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the

significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even

if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum

ratings.

Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook

(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test

report and estimated failure rate, etc).

=100 °C

Note 4: It is effective soldering area of Lead .

Note 5: Device considered a two terminal device: pins 1, 2 and 3 shorted together, and pins 4, 5 and 6 shorted

together.

Note 6: A ceramic capacitor(0.1

μF) should be connected from pin 6 to pin 4 to stabilize the operation of the high

gain linear amplifier. Failure to provide the bypassing may impair the switching property.

The total lead length between capacitor and coupler should not exceed 1 cm.

Recommended Operating Conditions

Characteristics

Symbol

Min

Typ.

Max

Unit

Input current, ON

(Note 7)

10

⎯

15

mA

Input voltage, OFF

0

⎯

0.8

V

Supply voltage

10

⎯

20

V

Peak output current

⎯

⎯

± 0.15

A

Operating temperature

⎯

100

°C

Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the

device. Additionally, each item is an independent guideline respectively. In developing designs using this

product, please confirm specified characteristics shown in this document.

Note 7: Input signal rise time (fall time)

< 0.5 μs.

Note 8: If the rising slope of the supply voltage (VCC) for the detector is steep, stable operation of the internal

circuits cannot be guaranteed.

Be sure to set 3.0V/

μs or less for a rising slope of the VCC.