E3Z

-@-IL@

9

Safety Precautions

Be sure to read the precautions for all models in the website at: www.omron

247.com.

Warning Indications

Meaning of Product Safety Symbols

This product is not designed or rated for ensuring

safety of persons either directly or indirectly.

Do not use it for such purposes.

The maximum power supply voltage is 30 VDC.

Before turning the power ON, make sure that the

power supply voltage does not exceed the maximum

voltage.

Never use the product with an AC power supply.

Otherwise, explosion may result.

Do not use the product with voltage in excess of the

rated voltage.

Excess voltage may result in malfunction or fire.

Do not use the product above rated load.

Be sure to follow the safety precautions below for added safety.

1. Do not use the sensor under the environment with explosive or

ignition gas.

2. Never disassemble, repair nor tamper with the product.

1. Do not use the product under the following conditions.

(1) In the place exposed to the direct sunlight.

(2) In the place where humidity is high and condensation may

occur.

(3) In the place where vibration or shock is directly transmitted to

the product.

2. Connection and Mounting

(1) If the sensor wiring is placed in the same conduits or ducts as

high-voltage or high-power lines, inductive noise may cause

malfunction or damage. Wire the cables separately or use a

shielded cable.

(2) Use an extension cable less than 100 m long for Standard I/O

mode and less than 20 m for IO-Link mode.

(3) Do not exceed the following force values applied to the cable.

Tensile: 80 N max., torque: 0.1 Nm max., pressure: 20 N max.,

flexure: 3 kg max.

M8 metal connectors

(4) Fasten a fixed implement by hand. If you use pliers, it may

cause malfunction or damage to it.

3. Cleaning

Do not use thinner, alcohol, or other organic solvents. Otherwise,

the optical properties and degree of protection may be degraded.

4. Power supply

When using a commercially available switching regulator, be sure

to ground the FG (Frame Ground) terminals.

5. Power supply reset time

The photoelectric switch will begin sensing no later than 100 ms

after the power is turned on. If the load and the photoelectric

switch is connected to different power supply, the photoelectric

switch must be always turned on first.

6. Turning off the power supply

When turning off the power, output pulse may be generated. We

recommend turning off the power supply of the load or load line

first.

7. Water resistance

Though this is type IP67, do not use in the water, rain or outdoors.

8. Please process it as industrial waste.

WARNING

Warning level

Indicates a potentially hazardous situation which,

if not avoided, will result in minor or moderate injury,

or may result in serious injury or death. Additionally

there may be significant property damage.

Precautions

for Safe Use

Supplementary comments on what to do or avoid

doing, to use the product safely.

Precautions

for Correct Use

Supplementary comments on what to do or avoid

doing, to prevent failure to operate, malfunction or

undesirable effect on product performance.

General prohibition

Indicates the instructions of unspecified prohibited

action.

Caution, explosion

Indicates the possibility of explosion under specific

conditions.

Caution, fire

Indicates the possibility of fires under specific

conditions.

WARNING

Precautions for Safe Use

Precautions for Correct Use