| 数据搜索系统,热门电子元器件搜索 |
|
STA2416 数据表(PDF) 25 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STA2416 数据表(HTML) 25 Page - STMicroelectronics |
|
25 / 38 page ![]() STA2416 General specification 25/38 6.10.2 Inquiry/page scan When only inquiry scan or page scan is enabled, the STA2416 will go in Sleep Mode or Deep Sleep Mode outside the receiver activity. The selection between Sleep Mode and Deep Sleep Mode depend on the UART activity like in SNIFF or PARK. 6.10.3 No connection If the Host places the UART in low power and there is no activity, then the STA2416 can be placed in Deep Sleep Mode. 6.10.4 Active link When there is an active link (SCO or ACL), the STA2416 cannot go in Deep Sleep Mode whatever the UART state is. But the STA2416 baseband is made such that whenever it is possible, depending on the scheduled activity (number of link, type of link, amount of data exchanged), it goes in Sleep Mode. 6.11 SW initiated low power mode A wide set of wake up mechanisms are supported. 6.12 Bluetooth™ - WLAN coexistence in collocated scenario The coexistence interface uses four GPIO pins, when enabled. Bluetooth™ and WLAN 802.11 b/g technologies occupy the same 2.4 GHz ISM band. STA2416 implements a set of mechanisms to avoid interference in a collocated scenario. The STA2416 supports five different algorithms in order to provide efficient and flexible simultaneous functionality between the two technologies in collocated scenarios. ● Algorithm 1: PTA (Packet Traffic Arbitration) based coexistence algorithm defined in accordance with the IEEE 802.15.2 recommended practice. ● Algorithm 2: the WLAN is the master and it indicates to the STA2416 when not to operate in case of simultaneous use of the air interface. ● Algorithm 3: the STA2416 is the master and it indicates to the WLAN chip when not to operate in case of simultaneous use of the air interface. ● Algorithm 4: Two-wire mechanism. ● Algorithm 5: Alternating Wireless Medium Access (AWMA), defined in accordance with the WLAN 802.11 b/g technologies. The algorithm is selected via HCI command. The default algorithm is algorithm 1. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |