Ultrasonic sensor

UC2000-30GM-IUR2-V15

3

Germany: +49 621 776 4411

Pepperl+Fuchs Group

Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.

USA: +1 330 486 0001

Singapore: +65 6779 9091

www.pepperl-fuchs.com

fa-info@us.pepperl-fuchs.com

fa-info@sg.pepperl-fuchs.com

fa-info@de.pepperl-fuchs.com

Description of Sensor Functions

Programming procedure

The sensor features 2 programmable analog outputs with programmable evaluation range. Programming the evaluation

range and the operating mode is done either via the sensor's RS232 interface and ULTRA3000 software (see the

ULTRA3000 software description) or by means of the programming plug at the sensor's back end which is described

here.

Programming of Evaluation Range

1. Disconnect supply voltage

2. Remove the programming plug to activate program mode.

3. Reconnect supply voltage (Reset)

4. Place the target at the desired position for A1

5. Momentarily insert the programming plug in position A1 and then remove. This will program the position A1.

6. Place the target at the desired position for A2

7. Momentarily insert the programming plug in position A2 and then remove. This will program the position A2.

Notes:

• Removing the programming plug saves the new position into the device memory.

• The programming status is indicated by the LED. A flashing green LED indicates that the target is detected; a flashing red LED indicates that

no target is detected.

Programming the Operation Mode

If the program mode is still activated, continue at number 4. If not, activate program mode by performing the sequence numbers 1 to 3.

1. Disconnect supply voltage

2. Remove the programming plug to activate program mode.

3. Reconnect supply voltage (Reset)

4. Insert the programming plug in position E2/E3. By removing and reinserting the plug, the user can toggle through the three different modes

of operation. The selected mode is indicated by the LEDs as shown below:

• Rising slope mode, LED A2 flashes

• Falling slope mode, LED A1 flashes

• Zero line mode, LEDs A1 and A2 flash

5. Once the desired mode is selected, insert the programming plug in position T. This completes the programming procedure and saves the

switch points and mode of operation.

6. The sensor now operates in normal mode.

Note:

The programming plug also functions as the temperature compensation. If the programming plug has not been inserted in the T position within 5

minutes, the sensor will return to normal operating mode with the latest saved values, without temperature compensation.

Factory settings

See technical data.

Display

The sensor provides LEDs to indicate various conditions.

Accessories

BF 30

Mounting flange, 30 mm

BF 30-F

Mounting flange with dead stop, 30 mm

BF 5-30

Universal mounting bracket for cylindrical sensors with a diameter of 5 ... 30 mm

UVW90-M30

Ultrasonic -deflector

UVW90-K30

Ultrasonic -deflector

UC-30GM-PROG

ULTRA3000

Software for ultrasonic sensors, comfort line

UC-30GM-R2

DA5-IU-2K-V

Process control and indication equipment

V15-G-2M-PVC

Female cordset, M12, 5-pin, PVC cable

Coded plug

A2

A1

T

E2/E3