STM32F446MC datasheet(21/202 Pages) STMICROELECTRONICS

21 / 202 page

DocID027107 Rev 6

21/202

STM32F446xC/E

Functional overview

3.11

Nested vectored interrupt controller (NVIC)

The devices embed a nested vectored interrupt controller able to manage 16 priority levels,

and handle up to 91 maskable interrupt channels plus the 16 interrupt lines of the Cortex®-

M4 with FPU core.

•

Closely coupled NVIC gives low-latency interrupt processing

•

Interrupt entry vector table address passed directly to the core

•

Allows early processing of interrupts

•

Processing of late arriving, higher-priority interrupts

•

Support tail chaining

•

Processor state automatically saved

•

Interrupt entry restored on interrupt exit with no instruction overhead

This hardware block provides flexible interrupt management features with minimum interrupt

latency.

3.12

External interrupt/event controller (EXTI)

The external interrupt/event controller consists of 23 edge-detector lines used to generate

interrupt/event requests. Each line can be independently configured to select the trigger

event (rising edge, falling edge, both) and can be masked independently. A pending register

maintains the status of the interrupt requests. The EXTI can detect an external line with a

pulse width shorter than the Internal APB2 clock period. Up to 114 GPIOs can be connected

to the 16 external interrupt lines.

3.13

Clocks and startup

On reset the 16 MHz internal RC oscillator is selected as the default CPU clock. The 16

MHz internal RC oscillator is factory-trimmed to offer 1% accuracy at 25 °C. The application

can then select as system clock either the RC oscillator or an external 4-26 MHz clock

source. This clock can be monitored for failure. If a failure is detected, the system

automatically switches back to the internal RC oscillator and a software interrupt is

generated (if enabled). This clock source is input to a PLL thus allowing to increase the

frequency up to 180 MHz. Similarly, full interrupt management of the PLL clock entry is

available when necessary (for example if an indirectly used external oscillator fails).

Several prescalers allow the configuration of the two AHB buses, the high-speed APB

(APB2) and the low-speed APB (APB1) domains. The maximum frequency of the two AHB

buses is 180 MHz while the maximum frequency of the high-speed APB domains is

90 MHz. The maximum allowed frequency of the low-speed APB domain is 45 MHz.

The devices embed a dedicated PLL (PLLI2S) and PLLSAI which allows to achieve audio

class performance. In this case, the I2S master clock can generate all standard sampling

frequencies from 8 kHz to 192 kHz.

STM32F446MC 数据表(PDF) 21 Page - STMicroelectronics

STM32F446MC 数据表(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载