9.2.3 Application Curve

Free-AirTemperature,T (

A °C)

I

= 440 A

OH

–

μ

Figure 9-2. High-Level Output Voltage vs Free-Air Temperature

9.3 Power Supply Recommendations

Place 0.1-µF bypass capacitors close to the power-supply pins to reduce errors coupling in from noisy or

high-impedance power supplies.

9.4 Layout

9.4.1 Layout Guidelines

For best operational performance of the device, use good PCB layout practices including:

• Noise can propagate into analog circuitry through the power pins of the circuit as a whole, as well as the

operational amplifier. Bypass capacitors are used to reduce the coupled noise by providing low impedance

power sources local to the analog circuitry.

• Connect low-ESR, 0.1-µF ceramic bypass capacitors between each supply pin and ground, placed as close

to the device as possible. A single bypass capacitor from V+ to ground is applicable for single supply

applications.

• Separate grounding for analog and digital portions of circuitry is one of the simplest and most-effective

methods of noise suppression. One or more layers on multilayer PCBs are usually devoted to ground planes.

A ground plane helps distribute heat and reduces EMI noise pickup. Make sure to physically separate digital

and analog grounds, paying attention to the flow of the ground current.

• To reduce parasitic coupling, run the input traces as far away from the supply or output traces as possible. If it

is not possible to keep them separate, it is much better to cross the sensitive trace perpendicular as opposed

to in parallel with the noisy trace.

• Place the external components as close to the device as possible. Keeping RF and RG close to the inverting

input minimizes parasitic capacitance.

• Keep the length of input traces as short as possible. Always remember that the input traces are the most

sensitive part of the circuit.

• Consider a driven, low-impedance guard ring around the critical traces. A guard ring can significantly reduce

leakage currents from nearby traces that are at different potentials.

AM26LS32AC, AM26LS32AI, AM26LS32AM

AM26LS33AC, AM26LS33AM

SLLS115G – OCTOBER 1980 – REVISED AUGUST 2023

www.ti.com

14

Submit Document Feedback

Copyright © 2023 Texas Instruments Incorporated

Product Folder Links: AM26LS32AC AM26LS32AI AM26LS32AM AM26LS33AC AM26LS33AM