5.15 Switching Characteristics—5-V Supply

VCC1 = VCC2 = 5 V ±10% (over recommended operating conditions unless otherwise noted)

PARAMETER

TEST CONDITIONS

MIN

TYP

MAX

UNIT

tPLH, tPHL

Propagation delay time

See Figure 6-1

6

11

17

ns

PWD

Pulse width distortion(1) |tPHL – tPLH|

0.6

5.9

ns

tsk(o)

Channel-to-channel output skew time(2)

Same-direction channels

4

ns

tsk(pp)

Part-to-part skew time(3)

4.5

ns

tr

Output signal rise time

See Figure 6-1

1.3

3.9

ns

tf

Output signal fall time

1.4

3.9

ns

tPHZ

Disable propagation delay, high-to-high impedance output

See Figure 6-2

8

22

ns

tPLZ

Disable propagation delay, low-to-high impedance output

8

20

ns

tPZH

Enable propagation delay, high impedance-to-high output for

ISO773x

7

20

ns

Enable propagation delay, high impedance-to-high output for

ISO773x with F suffix

3

8.5

μs

tPZL

Enable propagation delay, high impedance-to-low output for

ISO773x

3

8.5

μs

Enable propagation delay, high impedance-to-low output for

ISO773x with F suffix

7

20

ns

tDO

Default output delay time from input power loss

Measured from the time VCC goes

below 1.7V. See Figure 6-3

0.1

0.3

μs

tie

Time interval error

216 – 1 PRBS data at 100 Mbps

0.6

ns

(1)

Also known as pulse skew.

(2)

tsk(o) is the skew between outputs of a single device with all driving inputs connected together and the outputs switching in the same

direction while driving identical loads.

(3)

tsk(pp) is the magnitude of the difference in propagation delay times between any terminals of different devices switching in the same

direction while operating at identical supply voltages, temperature, input signals and loads.

www.ti.com

ISO7730, ISO7731

SLLSES0K – SEPTEMBER 2016 – REVISED SEPTEMBER 2025

Copyright © 2025 Texas Instruments Incorporated

Submit Document Feedback

17

Product Folder Links: ISO7730 ISO7731