M41T93RMY6F datasheet(40/56 Pages) STMICROELECTRONICS

40 / 56 page

Clock operation

M41T93

40/56

DocID12615 Rev 8

3.14.1

Active mode operation on VCC

On VCC, the operation of the output circuit is as shown in Table 11.

When OUT is 0 and FT is 0, the pin will be 0 regardless of whether any interrupts are

enabled.

When FT is a 1, the 512 Hz signal will be output if OUT is 0 or if no interrupts are enabled.

The interrupt sources control the pin when OUT is 1 and one or more of the interrupts are

enabled.

If OUT is 1, FT is 0 and no interrupts are enabled, then the pin will be 1.

Table 11. Priority for IRQ/FT/OUT pin when operating on VCC

OUT(1)

FT(2)

A1IE(3)

+ OFIE(4)

+ TIE(5)

+ watchdog(6)

running

Comment

When OUT is 0 and FT is not enabled, OUT dominates

and none of the interrupt sources have any effect.

512 Hz

When FT = 1 and OUT = 1 and no interrupts are enabled,

the output will be the 512 Hz frequency test (FT) signal.

IRQ

When one or more interrupts are enabled, and OUT is a 1,

the pin stays high until one of the interrupts is asserted.

When OUT is 1, FT is 0 and no interrupts are enabled, the

pin is high.

1. OUT is bit 7 of register 08h (digital calibration).

2. FT is bit 6 of register 08h (digital calibration).

3. A1IE is bit 7 of register 0Ah (alarm 1, month).

4. OFIE is bit 7 of register 09h (watchdog).

5. TIE is bit 5 of register 11h (timer control).

6. The watchdog is controlled by register 09h (watchdog).

M41T93RMY6F 数据表(PDF) 40 Page - STMicroelectronics

M41T93RMY6F 数据表(HTML) 40 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

数据表下载