L4901 datasheet(4/10 Pages) STMICROELECTRONICS

4 / 10 page

TEST CIRCUIT

APPLICATION INFORMATION

In power supplies for

µP systems it is necessaryto

provide power continuously to avoid loss of infor-

mation in memories and in time of day clocks, or to

save datawhen the primary supply is removed.The

L4901A makes it very easy to supply such equip-

ments ; it provides two voltage regulators (both 5 V

high precision) with separate inputs plus a reset

output for the data save function.

CIRCUIT OPERATION (see Figure 1)

After switch on Reg. 1 saturates until V01 rises to

the nominal value.

When the input 2 reaches VIT and the output 1 is

higher than VRT the output 2 (V02) switches on and

the reset output (VR) also goes high after a pro-

grammable time TRD (timing capacitor).

V02 and VR are switched togetherat low level when

one of the following conditions occurs :

- an input overvoltage

- an overload on the output 1 (V01 <VRT);

- a switch off (VIN <VIT -VITH);

and they start again as before when the condition

is removed.

An overload on output 2 does not switch Reg. 2,

and does not influence Reg. 1.

The V01 output features :

- 5 V internal reference without voltage divider

between the output and the error comparator ;

- very low drop series regulator element utilizing

current mirrors ;

permit high output impedance and then very low

leakage current error even in power down condi-

Figure 1

L4901A

4/10

L4901 数据表(PDF) 4 Page - STMicroelectronics

L4901 数据表(HTML) 4 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10

数据表下载