CLC001_06 datasheet(4/11 Pages) NSC

4 / 11 page

AC Electrical Characteristics

Over recommended operating supply and temperature ranges unless otherwise specified (Note 3)

Symbol

Parameter

Conditions

Min

Typ

Max

Units

r,tf

Rise time, Fall time

20%–80%, (Notes 4, 5)

400

800

Output overshoot

jit

Output jitter

(Note 7)

Propagation delay

(Note 5)

1.9

Note 1: “Absolute Maximum Ratings” are those values beyond which the safety of the device cannot be guaranteed. They are not meant to imply that the devices

should be operated at these limits. The table of “Electrical Characteristics” specifies conditions of device operation.

Note 2: Current flow into device pins is defined as positive. Current flow out of device pins is defined as negative. All voltages are stated referenced to VSS =0V.

Note 3: Typical values are at 25˚C and 3.3V.

Note 4: This parameter is Guaranteed by Design.

Note 5: RL =75Ω, AC-coupled at 270 Mbps, RREF = 1.91 kΩ 1% (for VSDO = 800 mVp-p ±10%), CL not greater than 5pF (See Figure 1)

Note 6: The VBB output is intended as a bias supply pin for the inputs of this device only. It is not designed as a power supply output and should not be used to

power other devices.

Note 7: RL =75Ω, AC-coupled at 622 Mbps, RREF = 1.5 kΩ 1% (for VSDO = 1.0 Vp-p ±10%), clock pattern input.

Note 8: Input Current Balance (IINB) is the difference between the Input Current (IIN)onVIN+ and VIN− for the same bias condition.

Test Loads

10132904

FIGURE 1. Test Loads

CLC001 数据表(PDF) 4 Page - National Semiconductor (TI)

CLC001 数据表(HTML) 4 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11

数据表下载