M29F016B datasheet(9/22 Pages) STMICROELECTRONICS

9 / 22 page

9/22

M29F016B

The Program/Erase Controller will suspend within

µs of the Erase Suspend Command being is-

sued. Once the Program/Erase Controller has

stopped the memory will be set to Read mode and

the Erase will be suspended. If the Erase Suspend

command is issued during the period when the

memory is waiting for an additional block (before

the Program/Erase Controller starts) then the

Erase is suspended immediately and will start im-

mediately when the Erase Resume Command is

issued. It will not be possible to select any further

blocks for erasure after the Erase Resume.

During Erase Suspend it is possible to Read and

Program cells in blocks that are not being erased;

both Read and Program operations behave as

normal on these blocks. Reading from blocks that

are being erased will output the Status Register. It

is also possible to enter the Auto Select mode: the

memory will behave as in the Auto Select mode on

all blocks until a Read/Reset command returns the

memory to Erase Suspend mode.

Erase Resume Command. The Erase Resume

command must be used to restart the Program/

Erase Controller from Erase Suspend. An erase

can be suspended and resumed more than once.

M29F016B 数据表(PDF) 9 Page - STMicroelectronics