DIMENSION GUIDE

6 of 21

Electrical Requirements - U.S.A.

Only

WARNING

Electrical Shock Hazard

Electrically ground range.

Failure to do so can result in death, fire, or

electrical shock.

If codes permit and a separate ground wire is used, it is

recommended that a qualified electrical installer determine that

the ground path and wire gauge are in accordance with local

codes.

Do not use an extension cord.

Be sure that the electrical connection and wire size are

adequate and in conformance with the National Electrical Code,

ANSI/NFPA 70-latest edition and all local codes and ordinances.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

WARNING: Improper connection of the equipment-grounding

conductor can result in a risk of electric shock. Check with a

qualified electrician or service technician if you are in doubt as

to whether the appliance is properly grounded. Do not modify

the power supply cord plug. If it will not fit the outlet, have a

proper outlet installed by a qualified electrician.

Electrical Connection

To properly install your range, you must determine the type of

electrical connection you will be using and follow the instructions

provided for it here.

■

Range must be connected to the proper electrical voltage and

frequency as specified on the model/serial/rating plate. The

model/serial/rating plate is located on the frame behind a top

corner of the door or either side of the drawer.

A. The model/serial/rating plate is located on the frame behind a top

corner of the door or either side of the drawer.

■

This range is manufactured with the neutral terminal

connected to the cabinet. Use a 3-wire, UL listed, 40 A or

50 A power supply cord (pigtail). See the following Range

Rating chart. If local codes do not permit ground through the

neutral, use a 4-wire power supply cord rated at 250 V, 40 A

or 50 A and investigated for use with ranges.

Range Rating*

Specified Rating of

Power Supply Cord Kit

and Circuit Protection

120/240 V

120/208 V

Ampere

8.8-16.5 kW

16.6-22.5 kW

7.8-12.5 kW

12.6-18.5 kW

40 or 50**

50**

*The NEC calculated load is less than the total connected load

listed on the model/serial/rating plate.

**For 50 A rated cord kits, use kits that specify use with a nominal

13/8" (34.9 mm) diameter connection opening.

■

A circuit breaker is recommended.

■

The range can be connected directly to the circuit breaker

box (or fused disconnect) through flexible or nonmetallic

sheathed, copper or aluminum cable. See the “Electrical

Connection - U.S.A. Only” section.

■

Allow 2 to 3 ft (61.0 cm to 91.4 cm) of slack in the line so that

the range can be moved if servicing is ever necessary.

■

A UL listed conduit connector must be provided at each end

of the power supply cable (at the range and at the junction

box).