Time Electronics

1017 Voltage/Current/Resistance Calibrator

Time Electronics Ltd, Unit 5, TON Business Park, 2-8 Morley Road, Tonbridge, Kent, TN9 1RA, United Kingdom

T: +44 (0) 1732 355993 | F: +44 (0) 1732 350198 | mail@timeelectronics.co.uk | www.timeelectronics.com

Description

A high performance portable multifunction calibrator with voltage,

current, and resistance ranges. The 1017 combines precision with

simple operation, making it suitable for use in the laboratory or field.

Constructed in a compact and durable plastic case with a tilt stand/

carry handle it takes up minimal bench space and is easily transportable.

Five DC voltage ranges from 10 mV to 100 V full scale are available,

each with a 6-digit (1 ppm) resolution. The DC current range is 100 mA

full scale with a 100 nA (1 ppm) resolution. Resistance from 0.01 Ω to

10 kΩ is available 0.01 Ω steps.

Stability and Temperature Coefficient

Long-term stability is achieved by the use of high quality components

and modern resistor technology. The 1017 features a precision

reference diode that provides the input to the units active circuitry.

The special low-thermal emf terminals reduce errors when working

with microvolt signals.

Digital Deviation Control

Allows the output to be increased and decreased in % terms from

0 to ± 0.999 %. This provides a direct read-out of error and simplifies

the recording results for calibration certificates. It enables the user to

immediately see if the unit under test is within specification.

Applications

The 1017 is suitable for calibrating and simulating a wide range of

instruments including thermocouples, transducers, 4 to 20 mA and

0 to 10 V transmitters, and platinum resistance thermometers.

It can also be used for testing ranges on multimeters and electrical

test tools with measurement capabilities.

Features

• DC voltage 10 nV to 100 V

• DC current 100 nA to 100 mA

• Resistance 10 mΩ to 10 kΩ

• Accuracy 0.005 % (50 ppm)

• 1 ppm setting resolution

• Noise < 2 ppm (0.1 to 1 Hz)

• Stability < 5 ppm/day, < 25 ppm/yr

• Deviation control - voltage and current

• Battery or mains operation

Portable Operation

The 1017 can be powered from mains supply or by the internal

rechargeable battery pack. Battery operation enables good

performance where earth loop and noise pick-up occurs. When the

calibrator is plugged into the mains supply the internal batteries will

automatically start to recharge.

If unplugged from the mains during operation the internal batteries will

continue to power the instrument. Full charge allows 12 hours typical

use. An LED indicator on the front panel displays the battery condition.