INSTRUCTION LEAFLET

WARNING: DO NOT USE NORMAL LOW VOLTAGE TRANSFORMERS WITH LEDS.

All LED fittings are tested before dispatch. It is not necessary to check them on site. Do not power up until fittings are wired correctly.

This product should be installed by a qualified electrician in accordance with all current, local legislation. For the UK, the current edition of the IEE

Wiring Regulations and European Standard IEC 60364.

LightGraphix, 20 Bourne Rd Ind. Park, Crayford, Kent, DA1 4BZ

Issue: 16 Jul 2014

LightGraphix reserves the right to change specification without notice

IPKit10

IP68 Connection Resin Kit for Wet/Exterior Environments

WARNING

Refer to specified driver sheet for correct wiring instructions.

Do not switch on power source prior to making these connections as this will result in the LEDs being overvolted and can lead to LED failure.

Do not switch on power until resin has had enough time to cure as stated in the instructions above.

Do not pour resin on live connections.

Connect pairs of cables (e.g. red + / black -) from LED fittings to specified driver. Multiple fittings of constant current LEDs are wired in series.

POLARITY IS CRITICAL!

If LEDs don’t work, turn power off immediately, then check polarity. Failure to do so will excessively heat up the LED, causing them to fail.

A maximum no. of 10 connections can be achieved with one IP68 connection kit

WIRING

Page 2/2

+

-

red

black

+

red

-

black

+

red

-

black

to next

fitting

driver

IN-SERIES CONNECTION

FOR CONSTANT

CURRENT WIRING

10 connections for

11 LED fittings.

LED

fitting

4 LED fittings per

IP connection.

PARALLEL CONNECTION

FOR CONSTANT

VOLTAGE WIRING

-

black

+

red

cable

from

driver

fitting

№2

fitting

№1

+

red

-

black

IN-SERIES EXAMPLE

Take time to prepare all

connections, use tape to hold

cables and containers in an upright

position.

Keep cables and terminal blocks

centralised within the container.

Connections will not be able to

bear weight until fully cured (a

minimum of 48hrs).