10

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

OPERATION

SWITCHING ON AND OFF

• To switch the sander on, push

the switch to position 1.

• To switch the sander off, push

the switch to position 0.

VARIABLE SPEED CONTROL

The variable speed control allows you to adapt the speed of the tool to the

workpiece material.

The rotation speed can be set

between 1600 rpm and 3000 rpm

with the speed control switch.

The speed control switch has 6 levels

marked on it >1< indicates the lowest

speed setting >6< the highest.

NOTE: The speed can also be

adjusted during operation as

described above.

• Use a low speed setting when

using a fine grit, when working with plastics or ceramics and when

removing painted or varnished surfaces.

• Use a high speed setting when using a coarse grit and when removing a

lot of material.