13

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

THE HIGH PRESSURE HOSE

CONNECT THE HOSE TO THE GUN

1. Slide the connector collar on the

hose backwards.

2. Push the gun into the connector.

3. Release the connector collar.

NOTE: Make sure the connection is

secure.

CONNECT THE HOSE TO THE POWER WASHER

1. Slide the connector collar on the

power washer towards the machine.

2. Push the hose into the connector.

3. Release the connector collar.

NOTE: Make sure the connection is

secure.

CONNECT WATER INLET HOSE

1. Remove the travel cap if fitted.

2. Fit the hose adaptor as shown.

3. Connect the water supply hose to the

hose adaptor.

NOTE: The water source must provide

a minimum of 17 litres per

minute @ 20 PSI.

NOTE: Make sure the water inlet hose

is screwed on tightly.