ST7LITE25 datasheet(71/131 Pages) STMICROELECTRONICS

71 / 131 page

ST7LITE2

71/131

SERIAL PERIPHERAL INTERFACE (Cont’d)

11.4.3.1 Functional Description

A basic example of interconnections between a

single master and a single slave is illustrated in

Figure 43.

The MOSI pins are connected together and the

MISO pins are connected together. In this way

data is transferred serially between master and

slave (most significant bit first).

The communication is always initiated by the mas-

ter. When the master device transmits data to a

slave device via MOSI pin, the slave device re-

sponds by sending data to the master device via

the MISO pin. This implies full duplex communica-

tion with both data out and data in synchronized

with the same clock signal (which is provided by

the master device via the SCK pin).

To use a single data line, the MISO and MOSI pins

must be connected at each node ( in this case only

simplex communication is possible).

Four possible data/clock timing relationships may

be chosen (see Figure 46) but master and slave

must be programmed with the same timing mode.

Figure 43. Single Master/ Single Slave Application

8-BIT SHIFT REGISTER

SPI

CLOCK

GENERATOR

8-BIT SHIFT REGISTER

MISO

MOSI

MISO

SCK

SLAVE

MASTER

+5V

MSBit

LSBit

MSBit

LSBit

Not used if SS is managed

by software

ST7LITE25 数据表(PDF) 71 Page - STMicroelectronics

ST7LITE25 数据表(HTML) 71 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载