Clock operations

M48T35 M48T35Y

14/29

minute, have one second either shortened by 128 or lengthened by 256 oscillator cycles. If

a binary '1' is loaded into the register, only the first 2 minutes in the 64 minute cycle will be

modified; if a binary 6 is loaded, the first 12 will be affected, and so on.

Therefore, each calibration step has the effect of adding 512 or subtracting 256 oscillator

cycles for every 125,829,120 actual oscillator cycles, that is +4.068 or –2.034 ppm of

adjustment per calibration step in the calibration register. Assuming that the oscillator is in

fact running at exactly 32,768 Hz, each of the 31 increments in the Calibration Byte would

represent +10.7 or –5.35 seconds per month which corresponds to a total range of +5.5 or –

2.75 minutes per month.

Two methods are available for ascertaining how much calibration a given M48T35/Y may

require. The first involves simply setting the clock, letting it run for a month and comparing it

to a known accurate reference (like WWV broadcasts). While that may seem crude, it allows

the designer to give the end user the ability to calibrate his clock as his environment may

require, even after the final product is packaged in a non-user serviceable enclosure. All the

designer has to do is provide a simple utility that accesses the Calibration Byte.

The second approach is better suited to a manufacturing environment, and involves the use

of some test equipment. When the Frequency Test (FT) Bit, the seventh-most significant bit

in the Day Register is set to a '1,' and D7 of the Seconds Register is a '0' (Oscillator

Running), DQ0 will toggle at 512 Hz during a READ of the Seconds Register. Any deviation

from 512 Hz indicates the degree and direction of oscillator frequency shift at the test

temperature. For example, a reading of 512.01024 Hz would indicate a +20 ppm oscillator

frequency error, requiring a –10 (WR001010) to be loaded into the Calibration Byte for

correction.

Note:

Setting or changing the Calibration Byte does not affect the Frequency Test output

frequency.

The FT Bit MUST be reset to '0' for normal clock operations to resume. The FT Bit is

automatically Reset on power-down.

Calibration.”

3.5

Century bit

Bit D5 and D4 of Clock Register 1FFCh contain the CENTURY ENABLE Bit (CEB) and the

CENTURY Bit (CB). Setting CEB to a '1' will cause CB to toggle, either from a '0' to '1' or

from '1' to '0' at the turn of the century (depending upon its initial state). If CEB is set to a '0,'

CB will not toggle.

Note:

The WRITE Bit must be set in order to write to the CENTURY Bit.