STW4810 datasheet(36/79 Pages) STMICROELECTRONICS

36 / 79 page

STw4810

Functional description

35/78

4.3.2

VCORE regulator: DC/DC step-down regulator

This regulator drives the core of the multimedia processor. VCORE is a DC/DC step-down

regulator that generates the regulated power supply with very high efficiency. The 15 voltage

levels enable dynamic voltage and frequency scaling suitable for any supply voltage of

CMOS process, they also follow the processor process roadmap. The regulated output

voltage levels are adjustable by the power control registers (

Table 22), via the main I2C

interface (SDA, SCL).

The master clock (13, 19.2 or 26 MHz) is automatically detected, squared and divided to

generate the switching clock of the SMPS. When this clock is not available, regulators run

the internal RC oscillator.

The DC/DC step-down regulator has the following main features;

●

Programmable output voltage, 15 levels from 1.0 V to 1.5 V (VCORE_SEL [3:0] bits of

power control register -

Table 22)

●

3 power domains:

–

‘Normal mode’ when multimedia processor is in run mode, 600 mA full load

–

‘Low current mode’ when multimedia processor is in sleep mode, 5 mA current

capability.

Fast switching from low current to normal mode.

The regulator is in ‘low current mode’ when multimedia processor is in sleep

mode. PWREN signal indicates that the multimedia processor is about to switch to

run mode. VDDOK signal indicates to the multimedia processor that all supplies

are in the specified range.

Note:

The definition of sleep mode is given in section 4.2.3: Sleep mode.

●

‘Power down mode’ or ‘standby mode’ when regulator is switched off, no consumption

(EN_VCORE bit of power control register -

Table 28)

●

Soft start circuitry at start up, from power off to normal mode, when PON ball changes

from “0” to “1”.

●

Default setting defined by start-up configuration.

4.3.3

VIO_VMEM regulator: DC/DC step- down regulator

VIO_VMEM step-down regulator has the same structure than VCORE.

The VIO_VMEM regulator supplies the IOs of the multimedia processor and its peripherals.

This regulator can be used to supply the memories working with the multimedia processor,

such as DDR-SDRAM. A switched mode power supply - voltage down converter is used to

generate the 1.8 V regulated power supply with very high efficiency.

The master clock (13, 19.2 or 26 MHz) is automatically detected, squared and divided to

generate the SMPS switching clock. When this clock is not available, regulators can run the

internal RC oscillator.

Main features

●

Fixed 1.8 V output voltage

●

Two power domains:

–

‘Normal mode’ when multimedia processor is in run mode - 600 mA full load

–

‘Low current mode’ when multimedia processor is in sleep mode, 5 mA current

capability.

STW4810 数据表(PDF) 36 Page - STMicroelectronics

STW4810 数据表(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79

数据表下载