STW4810 datasheet(49/79 Pages) STMICROELECTRONICS

49 / 79 page

Functional description

STw4810

48/78

4.5

SD/MMC/SDIO module

This block provides the power supply (1.8 V, 2.85 V or 3 V) and signal shifting functions

required to connect any of the following peripherals to the multimedia processor:

–SD card

–

MMC cards, low and 52 MHz high speed

–

SDIO cards (except SDIO card version 1.0 / Vsupply range: [3.1; 3.6] V

Cards detection is automatically done by the multimedia processor system. Following a card

detection, the multimedia processor starts the SD/MMC application by writing in the SD

MMC control register (

Table 18) to start LDO VMMC and then starts the protocol

initialization.

The module includes:

–

1.8 V, 2.85 V or 3 V voltage regulators (150 mA)

–

Five bidirectional level shifter channels compatible with 1.8 V, 2.85 V or 3 V

–

Two unidirectional lines for clock: multimedia processor to card and feedback clock

to multimedia processor for synchronization.

–

Four control signals for channel direction

Figure 13.

SD MMC block diagram

SD/ MMC/SDIO INTERFACE

1.8V,2.85V,3V

VBAT_VMMC

VMMC

DRIVER

Level

Shifter

LATCHCLK

CLKOUT

DATAOUT0

MCCLK

MCFBCLK

MCCMDDIR

MCDATA0DIR

MCDATA31DIR

MCCMD

MCDATA[3:1]

MCDATA0

SD, MMC

SDIO OR

CARDS

CMDOUT

5 * RB

DATAOUT[3:1]

Vsdc2

EMIF

MCDATA2DIR

3 * RA

150mA

STW4810 数据表(PDF) 49 Page - STMicroelectronics

STW4810 数据表(HTML) 49 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79

数据表下载