H8SXSLASH1663 datasheet(982/1158 Pages) RENESAS

982 / 1158 page

Section 21 Flash Memory (0.18-

µm F-ZTAT Version)

Rev.1.00 Jun. 07, 2006 Page 930 of 1102

REJ09B0294-0100

21.10

Programmer Mode

Along with its on-board programming mode, this LSI also has a programmer mode as a further

mode for the writing and erasing of programs and data. In programmer mode, a general-purpose

PROM programmer that supports the device types shown in table 21.13 can be used to write

programs to the on-chip ROM without any limitation.

Table 21.13 Device Types Supported in Programmer Mode

Target Memory

MAT

Product

Classification

ROM Size

Device Type

H8SX/1663

384 kbytes

User MAT

H8SX/1664

512 kbytes

FZTAT512V3A

21.11

Standard Serial Communication Interface Specifications for Boot

Mode

The boot program initiated in boot mode performs serial communication using the host and on-

chip SCI_4. The serial communication interface specifications are shown below.

The boot program has three states.

1. Bit-rate-adjustment state

In this state, the boot program adjusts the bit rate to achieve serial communication with the

host. Initiating boot mode enables starting of the boot program and entry to the bit-rate-

adjustment state. The program receives the command from the host to adjust the bit rate. After

adjusting the bit rate, the program enters the inquiry/selection state.

2. Inquiry/selection state

In this state, the boot program responds to inquiry commands from the host. The device name,

clock mode, and bit rate are selected. After selection of these settings, the program is made to

enter the programming/erasing state by the command for a transition to the

programming/erasing state. The program transfers the libraries required for erasure to the on-

chip RAM and erases the user MATs before the transition.

3. Programming/erasing state

Programming and erasure by the boot program take place in this state. The boot program is

made to transfer the programming/erasing programs to the on-chip RAM by commands from

the host. Sum checks and blank checks are executed by sending these commands from the

host.

H8SX/1663 数据表(PDF) 982 Page - Renesas Technology Corp

H8SX/1663 数据表(HTML) 982 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载