TDA9105 datasheet(19/32 Pages) STMICROELECTRONICS

19 / 32 page

OPERATING DESCRIPTION (continued)

Moire Function

Rs t

H-S YNC

Mono sta ble

V-SYNC

Figure 18 : Moire Function Block Diagram

MOIRE

ODD FRAME

EVEN FRAME

Figure 19 : Moire Output Waveform

Geometric Corrections

The principle is represented in Figure 20.

Starting from the vertical ramp, a parabola shaped

is generatedfor E/W correction, dynamic horizontal

phase control correction, and vertical dynamic Fo-

cus correction.

The core of the parabola generator is an analog

multiplier. The output current of which is equal to :

∆I= k (VRAMP -VDCIN)2.

Where VRAMP is the vertical ramp, typically com-

prised between 2 and 5V, VDCIN is a vertical DC

input adjustable in the range 3.2V

→ 3.8V in order

to generate a dissymmetric parabola if required

(keystone adjustment).

In order to keep good screen geometry for any end

user preferences adjustment we implemented the

possibility to have ”geometry tracking”. To enable

the ”tracking” function, the VDCOUT must be con-

nected to VDCIN.

It is possible to inhibit VPOS tracking by applying a

fixed DC voltage on the VDCIN Pin.

This DC voltage in that case must be taken from

the vertical reference and adjusted to 3.5V with an

external bridge resistor.

Due to large output stages voltage range (E/W,

BALANCE, FOCUS), the combination of tracking

function with maximum vertical amplitude max. or

min. vertical position and maximum gain on the DC

control inputs may leads to the output stages satu-

ration. This must be avoided by limiting the output

voltage by apropriate DC control voltages.

TDA9105

19/32

TDA9105 数据表(PDF) 19 Page - STMicroelectronics

TDA9105 数据表(HTML) 19 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

数据表下载