TS4902 datasheet(15/19 Pages) STMICROELECTRONICS

15 / 19 page

TS4902

15/19

s BTL Configuration Principle

The TS4902 is a monolithic power amplifier with a

BTL (Bridge Tied Load) output configuration. BTL

means that each end of the load is connected to

two single ended output amplifiers. Thus, we have:

Single ended output 1 = Vout1 = Vout (V)

Single ended output 2 = Vout2 = -Vout (V)

And Vout1 - Vout2 = 2Vout (V)

The output power is :

For the same power supply voltage, the output

power in BTL configuration is four times higher

than

the

output

power

single

ended

configuration.

s Gain In Typical Application Schematic

(cf. page 1)

In flat region (no effect of Cin), the output voltage

of the first stage is :

For the second stage : Vout2 = -Vout1 (V)

The differential output voltage is

The differential gain named gain (Gv) for more

convenient usage is :

Remark : Vout2 is in phase with Vin and Vout1 is

180 phased with Vin. It means that the positive

terminal of the loudspeaker should be connected

to Vout2 and the negative to Vout1.

s Low and high frequency response

In low frequency region, the effect of Cin starts.

Cin with Rin forms a high pass filter with a -3dB cut

off frequency

In high frequency region, you can limit the

bandwidth by adding a capacitor (Cfeed) in

parallel with Rfeed. Its form a low pass filter with a

-3dB cut off frequency

s Power dissipation and efficiency

Hypothesis :

• Voltage and current in the load are sinusoidal

(Vout and Iout)

• Supply voltage is a pure DC source (Vcc)

Regarding the load we have :

and

Then, the average current delivered by the supply

voltage is:

The power delivered by the supply voltage is

Psupply = Vcc IccAVG (W)

Then, the power dissipated by the amplifier is

Pdiss = Psupply - Pout (W)

and the maximum value is obtained when

and its value is:

Remark : This maximum value is only depending

on power supply voltage and load values.

)

(

)

Vout

(

Pout

RMS

Vout1 =

Vin

–

R fe ed

Ri n

-------------------- (V)

Vout2

Vo ut1 = 2Vin

–

Rfee d

Rin

-------------------- (V)

Gv =

Vout2

Vou t1

–

Vi n

--------------------------------------- = 2

Rfee d

Ri n

--------------------

F CL =

π Rin Cin

--------------------------------

()

FCH =

π Rfeed Cfeed

-----------------------------------------------

()

VOUT = VPEAK sinωt (V)

IOUT =

VOUT

R L

----------------- (A)

POUT =

VPEAK

2RL

---------------------- (W)

ICC

AVG

= 2

VPEAK

πRL

-------------------- (A)

Pdi ss =

22 Vcc

π RL

---------------------- POUT

POUT (W)

–

∂Pdiss

∂POUT

---------------------- = 0

)

(

Vcc

max

Pdiss

TS4902 数据表(PDF) 15 Page - STMicroelectronics

TS4902 数据表(HTML) 15 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

数据表下载