MPC5565 datasheet(49/54 Pages) FREESCALE

49 / 54 page

Revision History for the MPC5565 Data Sheet

MPC5565 Microcontroller Data Sheet, Rev. 2.0

Freescale Semiconductor

Revision History for the MPC5565 Data Sheet

The history of revisions made to this data sheet are shown in this section. The changes are divided into

each revision of this document. The substantive changes incorporated in MPC5565 Data Sheet Rev. 1.0 to

produce Rev. 2.0 of this document are grouped as follows:

•

Global and text changes

•

Table and figure changes

Within each group, the changes are listed in sequential order.

5.1

Changes to Revision 1.0 in Revision 2.0

The following table lists the substantive text changes made to paragraphs.

Table 28. Text Changes Between Rev. 1.0 and 2.0

Location

Description of Changes

Throughout:

Changed ‘TA = TL – TH’ to ‘TA = TL to TH.’

Title page:

Changed the Revision number from 1.0 to 2.0. Made the same changes in the lower left corner of the back page.

Section 1, “Overview”

• Fourth paragraph, First sentence: Deleted ‘of the MPC5500 family’; Second to last sentence: Deleted ‘can’.

• Fifth paragraph, First sentence: Replaced ‘MPC5500 family’ with ‘MPC5565’; Last sentence: Replaced ‘can be’

with ‘is’.

• Sixth paragraph, First sentence: Replaced ‘MPC5500 family’ with ‘MPC5565’;

• Second to last paragraph: Rewrote to read: The MCU has an on-chip enhanced queued dual analog-to-digital

converter (eQADC) The 324 package has 40-channels.

Section 3.1, “Maximum Ratings:

Changed title from ‘Maximum Rating’ to ‘Maximum Ratings.’

Section 3.2.1, “General Notes for Specifications at Maximum Junction Temperature”

Updated the address of Semiconductor Equipment and Materials International

3081 Zanker Rd.

San Jose, CA., 95134

(408) 943-6900

Section 3.7, “Power-Up/Down Sequencing”

Last paragraph: Changed the first sentence FROM , , , the voltage on the pins goes to high-impedance until . . .

TO. . .the pins go to a high-impedance state until . . .

Section 3.7.3, “Power-Down Sequence (VRC33 Grounded)”

Last sentence: Changed from: ‘This ensures that the digital 1.5 V logic, which is reset by the ORed POR only and

can cause the 1.5 V supply to decrease below its specification, is reset properly.’

To: ‘This ensures that the digital 1.5 V logic, which is reset only by an ORed POR and can cause the 1.5 V supply

to decrease less than its specification, resets correctly.’

MPC5565 数据表(PDF) 49 Page - Freescale Semiconductor, Inc

MPC5565 数据表(HTML) 49 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54

数据表下载