STM1066 datasheet(8/20 Pages) STMICROELECTRONICS

8 / 20 page

Operation

STM1066

8/20

Operation

The STM1066 connects or disconnects the output OUT, from the VIN pin based on the

logical combination of the enable input (EN), the inhibit input (INH), and the supply voltage

level, VCC (see Table 2 or Figure 11 for more details).

2.1

Output, OUT

If the enable input is in a logic high state and inhibit input is in a logic low state, the output

will be connected to VIN input as VCC rises above the VTH+ voltage threshold. Otherwise, the

output is connected to ground GND. The output is current limited (see Table 5).

2.2

Enable input, EN

A Logic low on the enable input disconnects the output from VIN and disables the device,

which enters a standby mode with very low current consumption (see Table 5).

2.3

Inhibit input, INH

A logic high on the inhibit input disconnects the output from VIN.

Table 2.

Truth table

VCC

EN(1)

Once the device is disabled by EN input, the VCC must be above VTH+ to reconnect output to VIN.

INH

OUT

<VTH+ (rising edge)

<VTH- (falling edge)

connected to GND

>VTH+ (rising edge)

>VTH- (falling edge)

connected to VIN

STM1066 数据表(PDF) 8 Page - STMicroelectronics