USB2513 datasheet(22/72 Pages) SMSC

22 / 72 page

USB 2.0 Hi-Speed Hub Controller

Datasheet

Revision 1.0 (3-11-09)

SMSC USB251x

DATASHEET

5.2

USB251x Pin Descriptions (Grouped by Function)

Table 5.2 USB251x Pin Descriptions

SYMBOL

BUFFER

TYPE

DESCRIPTION

UPSTREAM USB 2.0 INTERFACES

USBDM_UP

USBDP_UP

IO-U

USB Data

These pins connect to the upstream USB bus data signals (host, port, or

upstream hub).

VBUS_DET

I/O12

Detect Upstream VBUS Power

Detects state of Upstream VBUS power. The SMSC hub monitors

VBUS_DET to determine when to assert the internal D+ pull-up resistor which

signals a connect event.

When designing a detachable hub, this pin should be connected to VBUS on

the upstream port via a 2 to 1 voltage divider.

For self-powered applications with a permanently attached host, this pin must

be connected to 3.3 V (typically VDD33).

DOWNSTREAM USB 2.0 INTERFACES

USBDP_DN[x:1]/

PRT_DIS_P[x:1]

IO-U

Hi-Speed USB Data

These pins connect to the downstream USB peripheral devices attached to

the hub’s port. To disable, pull up with a 10 K resistor to 3.3 V.

USBDM_DN[x:1]/

PRT_DIS_M[x:1]

Downstream Port Disable Strap Option

If this strap is enabled by package and configuration settings (see Table 8.1,

"Hub Configuration Options"), then this pin will be sampled at RESET_N

negation to determine if the port is disabled.

To disable a port, pull up both PRT_DIS_M[x:1] and PRT_DIS_P[x:1] pins

corresponding to the port numbers.

PRTPWR[x:1] /

BC_EN[x]

O12

USB Power Enable

Enables power to USB peripheral devices downstream.

When PRTPWR_POL pin is unavailable, the hub supports active high power

controllers only.

When PRTPWR_POL pin is available, the active signal level of the PRTPWR

pins is determined by the power polarity strapping function of the

PRTPWR_POL pin.

IPD

Battery Charging Strap Option

*This feature is only available on USB251xB/Bi.

If this strap is enabled by package and configuration settings, (see Table 8.1,

"Hub Configuration Options"), this pin will be sampled at RESET_N negation

to determine if ports [x:1] support the battery charging protocol (and thus the

supporting external port power controllers) that would enable a device to draw

the currents per the USB battery charging specification.

BC_EN[x] = 1: Battery charging feature is supported for port x

BC_EN[x] = 0: Battery charging feature is not supported for

port x

USB2513 数据表(PDF) 22 Page - SMSC Corporation

USB2513 数据表(HTML) 22 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72

数据表下载