USB2513 datasheet(52/72 Pages) SMSC

52 / 72 page

USB 2.0 Hi-Speed Hub Controller

Datasheet

Revision 1.0 (3-11-09)

SMSC USB251x

DATASHEET

8.2.1.35

8.2.2

I2C EEPROM

The I2C EEPROM interface implements a subset of the I2C Master specification (Please refer to the

Philips Semiconductor Standard I2C-Bus specification for details on I2C bus protocols). The SMSC

hub’s I2C EEPROM interface is designed to attach to a single “dedicated” I2C EEPROM, and it

conforms to the Standard-mode I2C specification (100 kbit/s transfer rate and 7-bit addressing) for

protocol and electrical compatibility.

Note: Extensions to the I2C specification are not supported.

The hub acts as the master and generates the serial clock SCL, controls the bus access (determines

which device acts as the transmitter and which device acts as the receiver), and generates the START

and STOP conditions.

8.2.2.1

Implementation Characteristics

The hub will only access an EEPROM using the sequential read protocol.

8.2.2.2

Pull-Up Resistor

The circuit board designer is required to place external pull-up resistors (10 k

Ω recommended) on the

SDA / SMBDATA & SCL / SMBCLK / CFG_SEL[0] lines (per SMBus 1.0 specification, and EEPROM

manufacturer guidelines) to VDD33 in order to assure proper operation.

8.2.2.3

I2C EEPROM Slave Address

The slave address is 1010000.

Note: 10-bit addressing is NOT supported.

8.2.3

In-Circuit EEPROM Programming

The EEPROM can be programmed via ATE (automatic test equipment) by pulling RESET_N low

(which tri-states the hub’s EEPROM interface and allows an external source to program the EEPROM).

BIT

NUMBER

BIT NAME

DESCRIPTION

7:3

Reserved

INTF_PW_DN

SMBus Interface Power Down

‘0’ = Interface is active

‘1’ = Interface power down after ACK has completed

RESET

Reset the SMBus Interface and internal memory back to RESET_N

assertion default settings.

‘0’ = Normal Run/Idle State

‘1’ = Force a reset of registers to their default state

USB_ATTACH

USB Attach (and write protect)

‘0’ = SMBus slave interface is active

‘1’ = The hub will signal a USB attach event to an upstream device, and the

internal memory (address range 00h-FEh) is “write-protected” to prevent

unintentional data corruption.

USB2513 数据表(PDF) 52 Page - SMSC Corporation

USB2513 数据表(HTML) 52 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72

数据表下载