TLV2556-EP

TERMINAL FUNCTIONS

TERMINAL

I/O

DESCRIPTION

NAME

NO.

1–9,

AIN0–AIN10

I

Analog input. These 11 analog-signal inputs are internally multiplexed.

11, 12

Chip select. A high-to-low transition on CS resets the internal counters and controls and enables

CS

15

I

DATA OUT, DATA IN, and I/O CLOCK. A low-to-high transition disables DATA IN and I/O CLOCK

within a setup time.

Serial data input. The 4-bit serial data can be used as address selects the desired analog input

channel or test voltage to be converted next, or a command to activate other features. The input

DATA IN

17

I

data is presented with the MSB (D7) first and is shifted in on the first four rising edges of the I/O

CLOCK. After the four address/command bits are read into the command register CMR, I/O

CLOCK clocks the remaining four bits of configuration in.

The 3-state serial output for the A/D conversion result. DATA OUT is in the high-impedance state

when CS is high and active when CS is low. With a valid CS, DATA OUT is removed from the

high-impedance state and is driven to the logic level corresponding to the MSB(most significant

DATA OUT

16

O

bit)/LSB(least significant bit) value of the previous conversion result. The next falling edge of I/O

CLOCK drives DATA OUT to the logic level corresponding to the next MSB/LSB, and the remaining

bits are shifted out in order.

Status output, used to indicate the end of conversion (EOC) or an interrupt (INT) to host processor.

Programmed as INT (interrupt): INT goes from a high to a low logic level after the conversion is

INT/EOC

19

O

complete and the data is ready for transfer. INT is cleared by a rising I/O CLOCK transition.

Programmed as EOC: EOC goes from a high to a low logic level after the falling edge of the last I/O

CLOCK and remains low until the conversion is complete and the data is ready for transfer.

Ground. GND is the ground return terminal for the internal circuitry. Unless otherwise noted, all

GND

10

voltage measurements are with respect to GND.

Input /output clock. I/O CLOCK receives the serial input and performs the following four functions:

1.

It clocks the eight input data bits into the input data register on the first eight rising edges of

I/O CLOCK with the multiplexer address available after the fourth rising edge.

2.

On the fourth falling edge of I/O CLOCK, the analog input voltage on the selected multiplexer

input begins charging the capacitor array and continues to do so until the last falling edge of

I/O CLOCK

18

I

I/O CLOCK.

3.

The remaining 11 bits of the previous conversion data are shifted out on DATA OUT. Data

changes on the falling edge of I/O CLOCK.

4.

Control of the conversion is transferred to the internal state controller on the falling edge of the

last I/O CLOCK.

The maximum analog input voltage range is determined by the difference between the voltage

REF+

14

I/O

applied to terminals REF+ and REF–.

When the internal reference is used it is capable of driving a 10-k

Ω, 10-pF load.

Negative reference voltage. The lower reference voltage value (nominally ground) is applied to

REF–

13

I/O

REF–. This pin is connected to analog ground (GND of the ADC) when the internal reference is

used.

20

Positive supply voltage

Copyright © 2008–2009, Texas Instruments Incorporated

Submit Documentation Feedback

3

Product Folder Link(s): TLV2556-EP