GTL2003 datasheet(5/19 Pages) NXP

5 / 19 page

GTL2003_1

Product data sheet

Rev. 01 — 27 July 2007

5 of 19

NXP Semiconductors

GTL2003

8-bit bidirectional low voltage translator

Application design-in information

8.1 Bidirectional translation

For the bidirectional clamping conﬁguration, higher voltage to lower voltage or lower

voltage to higher voltage, the GREF input must be connected to DREF and both pins

pulled to HIGH side VCC through a pull-up resistor (typically 200 kΩ). A ﬁlter capacitor on

DREF is recommended. The processor output can be totem pole or open-drain (pull-up

resistors may be required) and the chip set output can be totem pole or open-drain

(pull-up resistors are required to pull the Dn outputs to VCC). However, if either output is

totem pole, data must be unidirectional or the outputs must be 3-stateable and the outputs

must be controlled by some direction control mechanism to prevent HIGH-to-LOW

contentions in either direction. If both outputs are open-drain, no direction control is

needed. The opposite side of the reference transistor (SREF) is connected to the

processor core power supply voltage. When DREF is connected through a 200 k

Ω resistor

to a 3.3 V to 5.5 V VCC supply and SREF is set between 1.0 V to (VCC − 1.5 V), the output

of each Sn has a maximum output voltage equal to SREF and the output of each Dn has

a maximum output voltage equal to VCC.

Typical bidirectional voltage translation.

Fig 4.

Bidirectional translation to multiple higher voltage levels such as an I2C-bus

application

GREF

DREF

002aac642

200 k

Ω

GTL2002

CHIPSET I/O

VCC

5 V

totem pole or

open-drain I/O

GND

SREF

increase bit size

by using 8-bit GTL2003,

10-bit GTL2010,

or 22-bit GTL2000

CHIPSET I/O

VCC

3.3 V

CPU I/O

VCORE

1.8 V

1.5 V

1.2 V

1.0 V

GTL2003 数据表(PDF) 5 Page - NXP Semiconductors

GTL2003 数据表(HTML) 5 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

数据表下载