TDF8590TH_2

© NXP B.V. 2007. All rights reserved.

Product data sheet

Rev. 02 — 23 April 2007

6 of 30

NXP Semiconductors

TDF8590TH

2

× 80 W SE (4 Ω) or 1 × 160 W BTL (8 Ω) class-D amplifier

If two or more class-D amplifiers are used in the same audio application, it is

recommended to synchronize the switching frequency of all devices to an external clock

(see Section 12.3).

6.4 Protections

The following protections are included in TDF8590TH:

– UnderVoltage Protection (UVP)

– OverVoltage Protection (OVP)

– Unbalance Protection (UBP)

The reaction of the device on the different fault conditions differs per protection and is

described in Section 6.4.1 to Section 6.4.5.

6.4.1 Thermal foldback

6.4.2 Overtemperature protection

6.4.3 Overcurrent protection

The OCP will detect a short-circuit between the loudspeaker terminals or if one of the

loudspeaker terminals is short-circuited to one of the supply lines.

If the output current tends to exceed the maximum output current of 8 A, the output

voltage of the TDF8590TH will be regulated to a level where the maximum output current

is limited to 8 A while the amplifier outputs remain switching, the amplifier does not shut

down. When this active current limiting continues longer than a time

τ (see Figure 5) the

capacitor on pin DIAG is discharged below a threshold value and the TDF8590TH shuts

down. Activation of current limiting and the triggering of the OCP is observed at pin DIAG

(see Figure 5).

A maximum value for the capacitor on pin DIAG is 47 pF. The reference voltage on pin