P89LPC922A1FDH datasheet(53/75 Pages) NXP

53 / 75 page

P89LPC92X1

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 2 — 1 December 2010

53 of 75

NXP Semiconductors

P89LPC9201/9211/922A1/9241/

8-bit microcontroller with 8-bit ADC

[1]

Typical ratings are not guaranteed. The values listed are at room temperature, 3 V.

[2]

The IDD(oper) specification is measured using an external clock with code while(1) {} executed from on-chip flash.

[3]

The IDD(idle) specification is measured using an external clock with no active peripherals, with the following functions disabled: real-time

clock and watchdog timer.

[4]

The IDD(pd) specification is measured using internal RC oscillator with the following functions disabled: comparators, real-time clock, and

watchdog timer.

[5]

The IDD(tpd) specification is measured using an external clock with the following functions disabled: comparators, real-time clock,

brownout detect, and watchdog timer.

[6]

See Section 9 “Limiting values” for steady state (non-transient) limits on IOL or IOH. If IOL/IOH exceeds the test condition, VOL/VOH may

exceed the related specification.

[7]

This specification can be applied to pins which have A/D input or analog comparator input functions when the pin is not being used for

those analog functions. When the pin is being used as an analog input pin, the maximum voltage on the pin must be limited to 4.0 V with

respect to VSS.

[8]

Pin capacitance is characterized but not tested.

[9]

Measured with port in quasi-bidirectional mode.

[10] Measured with port in high-impedance mode.

[11] Port pins source a transition current when used in quasi-bidirectional mode and externally driven from logic 1 to logic 0. This current is

highest when VI is approximately 2 V.

RRST_N(int) internal pull-up resistance

on pin RST

pin RST

Vref(bg)

band gap reference voltage

1.11

1.23

1.34

TCbg

band gap temperature

coefficient

-10

ppm/

°C

Table 12.

Static characteristics …continued

VDD = 2.4 V to 3.6 V unless otherwise specified.

Tamb = −40 °Cto+85 °C for industrial applications, unless otherwise specified.

Symbol

Parameter

Conditions

Min

Typ[1]

Max

Unit

P89LPC922A1FDH 数据表(PDF) 53 Page - NXP Semiconductors

P89LPC922A1FDH 数据表(HTML) 53 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75

数据表下载