MPC8572EPXATLB datasheet(73/140 Pages) FREESCALE

73 / 140 page

MPC8572E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 4

Freescale Semiconductor

High-Speed Serial Interfaces (HSSI)

Figure 43. Differential Voltage Definitions for Transmitter or Receiver

To illustrate these definitions using real values, consider the case of a CML (Current Mode Logic)

transmitter that has a common mode voltage of 2.25 V and each of its outputs, TD and TD, has a swing

that goes between 2.5 V and 2.0 V. Using these values, the peak-to-peak voltage swing of each signal (TD

or TD) is 500 mV p-p, which is referred as the single-ended swing for each signal. In this example, because

the differential signaling environment is fully symmetrical, the transmitter output’s differential swing

(VOD) has the same amplitude as each signal’s single-ended swing. The differential output signal ranges

between 500 mV and –500 mV, in other words, VOD is 500 mV in one phase and –500 mV in the other

phase. The peak differential voltage (VDIFFp) is 500 mV. The peak-to-peak differential voltage (VDIFFp-p)

is 1000 mV p-p.

15.2

SerDes Reference Clocks

The SerDes reference clock inputs are applied to an internal PLL whose output creates the clock used by

the corresponding SerDes lanes. The SerDes reference clocks inputs are SD1_REF_CLK and

SD1_REF_CLK for PCI Express and Serial RapidIO, or SD2_REF_CLK and SD2_REF_CLK for the

SGMII interface respectively.

The following sections describe the SerDes reference clock requirements and some application

information.

15.2.1

SerDes Reference Clock Receiver Characteristics

Figure 44 shows a receiver reference diagram of the SerDes reference clocks. Characteristics are as

follows:

•

The supply voltage requirements for XVDD_SRDS2 are specified in Table 1 and Table 2.

•

SerDes Reference Clock Receiver Reference Circuit Structure

—The SDn_REF_CLK and SDn_REF_CLK are internally AC-coupled differential inputs as

shown in Figure 44. Each differential clock input (SDn_REF_CLK or SDn_REF_CLK) has

on-chip 50-

Ω termination to SGND_SRDSn (xcorevss) followed by on-chip AC-coupling.

Differential Swing, VID or VOD = A – B

A Volts

B Volts

SDn_TX or

SDn_RX

SDn_TX or

SDn_RX

Differential Peak Voltage, VDIFFp = |A – B|

Differential Peak-Peak Voltage, VDIFFpp = 2*VDIFFp (not shown)

Vcm = (A + B) / 2

MPC8572EPXATLB 数据表(PDF) 73 Page - Freescale Semiconductor, Inc

MPC8572EPXATLB 数据表(HTML) 73 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载