AD7466BRTZ-R datasheet(19/28 Pages) AD

19 / 28 page

AD7466/AD7467/AD7468

Rev. C | Page 19 of 28

NORMAL MODE

The AD7466/AD7467/AD7468 automatically enter power-

down at the end of each conversion. This mode of operation is

designed to provide flexible power management options and to

optimize the power dissipation/throughput rate ratio for low

power application requirements. Figure 24 shows the general

operation of the AD7466/AD7467/AD7468. On the CS falling

edge, the part begins to power up and the track-and-hold,

which was in hold while the part was in power-down, goes into

track mode. The conversion is also initiated at this point. On

the third SCLK falling edge after the CS falling edge, the track-

and-hold returns to hold mode.

For the AD7466, 16 serial clock cycles are required to complete

the conversion and access the complete conversion result. The

AD7466 automatically enters power-down mode on the 16th

SCLK falling edge.

For the AD7467, 14 serial clock cycles are required to complete

the conversion and access the complete conversion result. The

AD7467 automatically enters power-down mode on the 14th

SCLK falling edge.

For the AD7468, 12 serial clock cycles are required to complete

the conversion and access the complete conversion result.

The AD7468 automatically enters power-down mode on the

12th SCLK falling edge.

The AD7466 also enters power-down mode if CS is brought

high any time before the 16th SCLK falling edge. The conver-

sion that was initiated by the CS falling edge terminates and

SDATA goes back into three-state. This also applies for the

AD7467 and AD7468; if CS is brought high before the conver-

sion is complete (the 14th SCLK falling edge for the AD7467,

and the 12th SCLK falling edge for the AD7468), the part enters

power-down, the conversion terminates, and SDATA goes back

into three-state.

Although CS can idle high or low between conversions,

bringing CS high once the conversion is complete is recom-

mended to save power.

When supplies are first applied to the devices, a dummy conver-

sion should be performed to ensure that the parts are in power-

down mode, the track-and-hold is in hold mode, and SDATA is

in three-state.

Once a data transfer is complete (SDATA has returned to three-

state), another conversion can be initiated after the quiet time,

tQUIET, has elapsed, by bringing CS low again.

THE PART BEGINS

TO POWER UP

AD7468 ENTERS POWER-DOWN

AD7467 ENTERS POWER-DOWN

AD7466 ENTERS POWER-DOWN

VALID DATA

SCLK

SDATA

THE PART IS POWERED UP

AND VIN FULLY ACQUIRED

Figure 24. Normal Mode Operation

AD7466BRTZ-R 数据表(PDF) 19 Page - Analog Devices

AD7466BRTZ-R 数据表(HTML) 19 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

数据表下载