70592C datasheet(69/314 Pages) MICROCHIP

69 / 314 page

DS70592C-page 69

PIC24HJXXXGPX06A/X08A/X10A

6.0

RESET

The Reset module combines all Reset sources and

controls the device Master Reset Signal, SYSRST. The

following is a list of device Reset sources:

• POR: Power-on Reset

• BOR: Brown-out Reset

•MCLR: Master Clear Pin Reset

•SWR: RESET Instruction

• WDT: Watchdog Timer Reset

• TRAPR: Trap Conflict Reset

• IOPUWR: Illegal Opcode and Uninitialized W

A simplified block diagram of the Reset module is

shown in Figure 6-1.

Any active source of Reset will make the SYSRST sig-

nal active. Many registers associated with the CPU and

peripherals are forced to a known Reset state. Most

registers are unaffected by a Reset; their status is

unknown on POR and unchanged by all other Resets.

All types of device Reset will set a corresponding status

bit in the RCON register to indicate the type of Reset

(see Register 6-1). A POR will clear all bits, except for

the POR bit (RCON<0>), that are set. The user can set

or clear any bit at any time during code execution. The

RCON bits only serve as status bits. Setting a particular

Reset status bit in software does not cause a device

Reset to occur.

The RCON register also has other bits associated with

the Watchdog Timer and device power-saving states.

The function of these bits is discussed in other sections

of this manual.

FIGURE 6-1:

RESET SYSTEM BLOCK DIAGRAM

Note 1: This data sheet summarizes the features

of the PIC24HJXXXGPX06A/X08A/X10A

family of devices. However, it is not

intended

comprehensive

reference source. To complement the

information in this data sheet, refer to

Section 8. “Reset” (DS70229) of the

“dsPIC33F/PIC24H Family Reference

Manual”, which is available from the

Microchip website (www.microchip.com).

2: Some registers and associated bits

described in this section may not be

available on all devices. Refer to

Section 4.0 “Memory Organization” in

this data sheet for device-specific register

and bit information.

Note:

Refer to the specific peripheral or CPU

section of this manual for register Reset

states.

Note:

The status bits in the RCON register

should be cleared after they are read so

that the next RCON register value after a

device Reset will be meaningful.

MCLR

VDD

Internal

Regulator

BOR

Sleep or Idle

RESET Instruction

WDT

Module

Glitch Filter

Trap Conflict

Illegal Opcode

Uninitialized W Register

SYSRST

VDD Rise

Detect

POR

70592C 数据表(PDF) 69 Page - Microchip Technology

70592C 数据表(HTML) 69 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载