TNETX3270 datasheet(27/66 Pages) TI1

27 / 66 page

TNETX3270

ThunderSWITCH

™ 24/3 ETHERNET™ SWITCH

WITH 24 10-MBIT/S PORTS AND 3 10-/100-MBIT/S PORTS

SPWS043B – NOVEMBER 1997 – REVISED APRIL 1999

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

EEPROM interface

The EEPROM interface is provided so the system-level manufacturer can produce a CPU-less, preconfigured

system to their customers. Customers also may want to change or reconfigure their system and retain their

preferences between system power downs. The device cannot be used without either an EEPROM or CPU

connected to it (see Figure 5).

The EEPROM contains configuration and initialization information that are accessed infrequently, typically at

power up and after a reset. The organization of the EEPROM data is in accordance with the DIO address map.

EEPROM downloads can be initiated in one of two ways:

D At the end of hard reset (rising edge on RESET, or completion of a DIO write to DIOaddrhi register that

changes the value of the three most significant bits from 010 to another value).

D Writing a 1 to load in Syscontrol register. This bit is cleared automatically when the download completes.

It cannot be set during the download by the EEPROM data, thereby preventing a download loop.

During the download, no DIO writes are permitted. If a DIO write is attempted, SRDY is held high until the

download has completed.

The EEPROM size is detected automatically according to the address assigned to the EEPROM:

D 2048 bits organized as a 256 × 8 EEPROM should have its A0, A1, and A2 pins tied low.

D 8192 bits organized as a 1024 × 8 EEPROM should have its A0 and A1 pins tied low and A2 pin tied high.

TNETX3270

EDIO

ECLK

24C0x

Flash EEPROM

SCL

SDA

GND

24C02 = GND

24C08 = VDD

Figure 5. EEPROM Interface Connections

After the initial start condition, a slave address containing a device address of 000 is output on EDIO, and then

EDIO is observed for an acknowledge from the EEPROM. If an acknowledge is received, operation continues

for the 24C02 EEPROM. If none is received, a stop condition is generated, followed by another start condition

and slave address, this time containing a device address of 100. If this receives no acknowledge, no EEPROM

is present, and device operation continues, using the current register settings (i.e., those following a hardware

reset, or those previously entered by software).

When this device is driving EDIO, it drives out only a strong logic 0. When a logic 1 is intended to be driven out,

the pin must be resistively pulled high. An on-chip 50-

µA current-source pullup device is provided on this pin.

The system designer must decide if this is sufficient to achieve a logic 1 level in a timely manner or if an external

supplementary resistor is required.

TNETX3270 数据表(PDF) 27 Page - Texas Instruments

TNETX3270 数据表(HTML) 27 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

数据表下载