Getting Started

www.ti.com

1.1

Evaluation Module Operating Parameters

The following table lists the operating conditions for the DRV2603 on the evaluation module.

Parameter

Specification

Supply voltage range

2.5V to 5.2V

Power-supply Current Rating

400mA

External PWM Voltage, V

1.8V to V

DD

1.2

Quick Start Board Setup

The DRV2603EVM-CT firmware contains haptic effects which showcase the features and benefits of the

DRV2603. Follow the instructions below to begin the demo.

1. Out of the box, the jumpers are set to begin demo mode using USB power. The default jumper settings

can be found in the table below.

Jumper

Default Position

Description

JP1

Shorted

Connect MSP430 PWM output to DRV2603 PWM input

JP2

Shorted

3.3V reference for I

JP3, JP4

Shorted

Connect on-board actuators to DRV2603

MSP

USB to MSP

Select USB (5V) or VBAT power for the MSP430

DRV

USB to DRV

Select USB (5V) or VBAT power for the DRV2603

2. Connect the included mini-USB cable to the USB connector on the DRV2603EVM-CT board.

3. Connect the other end of the USB cable to an available USB port on a computer, USB charger, or USB

battery pack.

4. If the board is powered correctly the four colored LEDs will light up, the four mode LEDs will flash, and

the LRA and ERM will play an effect, indicating the board has been successfully initialized.

4

DRV2603 ERM/LRA Haptic Driver Evaluation Kit

SLOU340A – May 2012 – Revised May 2012

Submit Documentation Feedback

Copyright © 2012, Texas Instruments Incorporated