13

PRObeS

zS Series High Impedance

Active Probes

ZS2500, ZS1500, ZS1000,

ZS2500-QUADPAK,

ZS1500-QUADPAK,

ZS1000-QUADPAK

The ZS Series probes provide high impedance and an

extensive set of probe tips and ground accessories to

handle a wide range of probing scenarios. The high

1 M

Ω input resistance and low 0.9 pF input capacitance

mean this probe is ideal for all frequencies. The ZS Series

probes provide full system bandwidth for all Teledyne

LeCroy oscilloscopes having bandwidths of 1 GHz

and lower.

Differential Probes

(200 MHz – 1.5 GHz)

ZD1500, ZD1000, ZD500,

ZD200

High bandwidth, excellent common-mode rejection ratio

(CMRR) and low noise make these active differential

probes ideal for applications such as automotive

development (e.g. FlexRay) and failure analysis, as well

as wireless and data communication design. The ProBus

interface allows sensitivity, offset and common-mode

range to be displayed on the oscilloscope screen.

High Voltage

Differential Probes

ADP305, ADP300, AP031

Low cost active differential probes are intended for

measuring higher voltages. The differential techniques

employed permit measurements to be taken at two

points in a circuit without reference to the ground,

allowing the oscilloscope to be safely grounded without

the use of opto-isolators or isolating transformers.

High Voltage

Passive Probes

PPE1.2KV, PPE20KV,

PPE2KV, PPE4KV, PPE5KV,

PPE6KV

The PPE Series includes five fixed-attenuation probes

covering a range from 2 kV to 20 kV, and one switchable

probe providing ÷10/÷100 attenuation for voltage inputs

up to 1.2 kV. All fixed-attenuation, standard probes

automatically rescale compatible Teledyne LeCroy

oscilloscopes for the appropriate attenuation of the probe.

Current Probes

CP031, CP030, AP015,

CP150, CP500, DCS015

Available current probes reach bandwidths of 100 MHz,

peak currents of 700 A and sensitivities of 10 mA/div. Use

multiple current probes to make measurements on three-

phase systems or a single current probe with a voltage

probe to make instantaneous power measurements.

Teledyne LeCroy current probes enable the design and

testing of switching power supplies, motor drives, electric

vehicles, and uninterruptible power supplies.

The right probe is an essential tool for accurate signal capture and Teledyne LeCroy offers an extensive range of

probes to meet virtually every probing need.