ACE24C02A

Two-wire Serial EEPROM

VER 1.4

6

Stop Condition:

A low-to-high transition of SDA with SCL high is a stop condition. After a read sequence, the stop command

will place the EEPROM in a standby power mode (refer to Figure 5).

Acknowledge:

All addresses and data words are serially transmitted to and from the EEPROM in 8-bit words. The

EEPROM sends a zero during the ninth clock cycle to acknowledge that it has received each word. The

happens during the ninth clock cycle. Following receipt each word from the EEPROM, the

microcontroller should send a zero to EEPROM and continue to output the next data word or send a

stop condition to finish the read cycle.

Standby Mode :

The ACE24C02A features a low-power standby mode which is enabled: (a) upon power-up and (b) after

the receipt of the stop bit and the completion of any internal operations.

Device Reset :

After an interruption in protocol power loss or system reset, any two-wire part can be protocol reset by following

these steps:

1. Clock up to 9 cycles.

2. Look for SDA high in each cycle while SCL is high and then.

3. Create a start condition as SDA is high.

Bus Timing

Figure 2．SCL: Serial Clock, SDA: Serial Data I/O