3M

(2)

Typical Physical Properties and Performance Characteristics

Note: The following technical information and data should be considered representative or typical only and should not be

used for specification purposes.

Electrical Properties

Contact Resistance:

Substrate Tested (Foil/Rigid Plate)

Aluminum/

Aluminum/

Copper/

Copper/

Aluminum

Stainless Steel

Stainless Steel

Copper

< 2.5

Ω

< 2.0

Ω

< 1.0

Ω

< 0.5

Ω

Based upon four wire (Kelvin probe) resistance measurements made with crossed pieces of

Foil/3M™ XYZ-Axis Electrically Conductive Tape 9713/Rigid plate construction using a 1.0 in x

1.0 in square piece of 3M tape 9713. The rigid metal surface was prepared with a Scotch-Brite™

pad to roughen the surface and cleaned with isopropyl alcohol.

Outgassing:

Total Mass Loss (TML): 1.60%

(ASTM E-595)

Collected Volatile Condensed Materials (CVCM): 0.03%

Water Vapor Recovered (WVR) 0.36%

Minimum Overlap Length:

1/4 in. (6 mm)

Minimum Overlap Width:

1/8 inch (3 mm)

Adhesion Properties

Adhesion in oz/in (g/cm)

15 min. at

1 hr. at

24 hr. at

1 hr. at

24 hr. at

Substrate

72°F (22°C)

72°F (22°C)

72°F (22°C)

158°F (70°C)

158°F (70°C)

Stainless Steel

> 30 (335)

> 45 (502)

> 50 (558)

> 50 (558)

> 55 (613)

Aluminum

> 20 (223)

> 35 (390)

> 40 (446)

> 40 (446)

> 55 (613)

Copper

> 20 (223)

> 40 (446)

> 45 (502)

> 40 (446)

> 60 (669)

Based upon a 90 degree peel sample, following ASTM D3330 test method. Aluminum foil (2 mil thick) was used as the flexible backing

to the 3M tape 9713. The substrates listed are all rigid metal plates. The 158°F (70°C) aged peel samples are indicative of the typical

long term adhesion build expected at room temperature.

Operative Temperature Range and Shelf Life

Short Term Exposure (minutes, hours)

Long Term (days, weeks)

250°F (121°C)

158°F (70°C)

Shelf Life of Tape in Roll Form:

24 months from date of manufacture when stored in original cartons at 70°F (21°C) and

50% relative humidity.

Available Widths:

Standard Length

Maximum Length*

1/4 inch - 14 inch

36 yd

108 yd

(5 mm - 356 mm)

(32.9 m)

(98.8 m)

Nominal Slitting Tolerance:

1/32 in (0.8 mm)

*Special requirements for long lengths should be discussed with 3M Customer Service personnel.

Available Sizes