| 数据搜索系统,热门电子元器件搜索 |
|
MCP4641 数据表(PDF) 54 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
MCP4641 数据表(HTML) 54 Page - Microchip Technology |
|
54 / 102 page ![]() MCP453X/455X/463X/465X DS22096B-page 54 2008-2013 Microchip Technology Inc. 7.4 Write Data Normal and High Voltage The Write command can be issued to both the volatile and nonvolatile memory locations. The format of the command (see Figure 7-2), includes the I2C Control Byte, an A bit, the MCP4XXX Command Byte, an A bit, the MCP4XXX Data Byte, an A bit, and a Stop (or Restart) condition. The MCP4XXX generates the A/A bits. A Write command to a volatile memory location changes that location after a properly formatted Write Command and the A/A clock have been received. 7.4.1 SINGLE WRITE TO VOLATILE MEMORY For volatile memory locations, data is written to the MCP4XXX after every byte transfer (during the Acknowledge). If a Stop or Restart condition is gener- ated during a data transfer (before the A), the data will not be written to the MCP4XXX. After the A bit, the master can initiate the next sequence with a Stop or Restart condition. Refer to Figure 7-2 for the byte write sequence. 7.4.2 CONTINUOUS WRITES TO VOLATILE MEMORY A continuous write mode of operation is possible when writing to the volatile memory registers (address 00h, 01h, and 04h). This continuous write mode allows writes without a Stop or Restart condition or repeated transmissions of the I2C Control Byte. Figure 7-3 shows the sequence for three continuous writes. The writes do not need to be to the same volatile memory address. The sequence ends with the master sending a STOP or RESTART condition. 7.4.3 THE HIGH VOLTAGE COMMAND (HVC) SIGNAL The High Voltage Command (HVC) signal is multiplexed with Address 0 (A0) and is used to indicate that the command, or sequence of commands, are in the High Voltage operational state. High Voltage commands allow the device’s WiperLock Technology and write protect features to be enabled and disabled. The HVC pin has an internal resistor connection to the MCP45XX/46XXs internal VDD signal. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |