Temperature Controller

E5CS--X

A--152

Installation

J Mounting

All E5CS-X models conform to DIN 43700 standard. Recom-

mended panel thickness is 1 to 4 mm (0.04 to 0.16 in).

Insert the temperature controller, back end first, into the panel

cutout. Mount the adapter (Y92F-30) supplied with each unit by

pushing it forward from the back of the temperature controller.

Push the adapter as close as possible to the front panel of the

temperature controller to eliminate the gap between them. Then,

secure the adapter with screws as shown.

Removal

Loosen the screws on the adapter and push the hook open to

remove the adapter.

Hook

Screw

J Connections

Connection Examples

Use M3.5 solderless terminals with the temperature controller’s

M3.5 self-rising pressure plate screws.

For solder-dipped leads, strip the lead wire 6 to 12 mm (0.24 to

0.47 in) and carefully insert the wire tip. Do not tighten the termi-

nal screw with excessive force.

7.5

(0.29)

7.3 (0.29)

max.

19

(0.75)

6to12

(0.24to0.47)

Precautions

J Environment

Do not install the temperature controller in a location where there

is a lot of dust or corrosive gases. Also avoid a location where

the temperature controller is subjected to heavy vibration, shock,

splashes of water or oil, and high temperatures.

Separate the temperature controller from equipment that

generates strong, high-frequency electrical noise such as welding

equipment.

Sensor Input Connections

The lead wires connecting the platinum RTD to the temperature

controller must be separated from the power lines an the load

lines, wherever possible, to prevent them from being inducted by

electrical noise.

Use the specified compensating conductors for the thermocouple

input type temperature controllers.

Use lead wires having a small resistance for the platinum RTD

type temperature controllers.

Sequence Circuit

Several seconds are required until the relay is turned ON after

the power has been applied to the temperature controller. Be

sure to take this time lag into consideration when designing a

sequence circuit which incorporates this temperature controller.

J Recalibration

The E5CS-X temperature controller can be recalibrated by a

factory-authorized repair service. Contact Omron for the location

near you.

Unauthorized recalibration of the controller will void the warranty

and may lead to erratic operation.