Evaluation Board User Guide

UG-287

Rev. B | Page 3 of 12

MECHANICAL SETUP/INSTALLATION

IMU INSTALLATION

Figure 4 provides a top level view of the EVAL-ADIS printed

circuit board (PCB), which provides two electrical connectors

(J1, J4) and a series of mounting holes. Table 1 provides the mating

connector and mounting hole identifiers for each compatible

product as well as the mounting hardware, the power supply

settings (JP1), and the most appropriate reference picture for each

compatible product (and future product support plans). Note

that inclusion in Table 1 does not necessarily reflect full support

of a particular product; that requires application software. Refer

to the www.analog.com/EVAL-ADIS for the most recent list of

supported products.

When installing an iSensor product on the EVAL-ADIS, do not

plug it into the PC-USB port or any other potential source of

power, before the installation is complete. Before pressing the

mating connector into J4, ensure that the pins align correctly.

For the ADIS16375, ADIS16485, and ADIS16488, installing JP2

across both leads provides 3.3 V of power to the real-time clock

power pin.

Figure 2. ADIS16488 Installation Example

When installing the ADIS16334 or ADIS16448, use the flexible

cable to connect the device to J4 on the EVAL-ADIS. Note that

these products and the associated flexible cable have only 20 pins.

J4, on the other hand, has 24-pins; therefore, ensure that the

flexible cable connects to Pin 1 to Pin 20 on J4 and aligns correctly

prior to plugging the USB cable into the USB connection on the

EVAL-ADIS. Ignore the Pin 1 markings on the flexible connector

because these markings do not reflect the correct Pin 1 con-

nections with respect to the ADIS16334/ADIS16448 or J4 on

the EVAL-ADIS.

Figure 3. ADIS16448/PCBZ Installation Example

Table 1 provides additional details for installing other products

onto the EVAL-ADIS. For additional installation instructions,

see the product-specific Wiki User Guide links, under

Documentation at www.analog.com/EVAL-ADIS.

Figure 4. Top Level View of PCB

129.413mm

67.7mm

47.2mm

41.4mm

55.9mm

2.9mm

2.9mm