LMV331M7X datasheet(8/32 Pages) TI

8 / 32 page

LMV331-N, LMV339-N, LMV393-N

SNOS018G – AUGUST 1999 – REVISED FEBRUARY 2013

www.ti.com

APPLICATION CIRCUITS

BASIC COMPARATOR

A basic comparator circuit is used for converting analog signals to a digital output. The LMV331-N/393-N/339-N

have an open-collector output stage, which requires a pull-up resistor to a positive supply voltage for the output

to switch properly. When the internal output transistor is off, the output voltage will be pulled up to the external

positive voltage.

The output pull-up resistor should be chosen high enough so as to avoid excessive power dissipation yet low

enough to supply enough drive to switch whatever load circuitry is used on the comparator output. On the

LMV331-N/393-N/339-N the pull-up resistor should range between 1k to 10k

Ω.

The comparator compares the input voltage (VIN) at the non-inverting pin to the reference voltage (VREF) at the

inverting pin. If VIN is less than VREF, the output voltage (VO) is at the saturation voltage. On the other hand, if VIN

is greater than VREF, the output voltage (VO) is at VCC.

Figure 12. Basic Comparator

COMPARATOR WITH HYSTERESIS

The basic comparator configuration may oscillate or produce a noisy output if the applied differential input

voltage is near the comparator's offset voltage. This usually happens when the input signal is moving very slowly

across the comparator's switching threshold. This problem can be prevented by the addition of hysteresis or

positive feedback.

INVERTING COMPARATOR WITH HYSTERESIS

The inverting comparator with hysteresis requires a three resistor network that are referenced to the supply

voltage VCC of the comparator. When Vin at the inverting input is less than Va, the voltage at the non-inverting

node of the comparator (Vin < Va), the output voltage is high (for simplicity assume VO switches as high as VCC).

The three network resistors can be represented as R1//R3 in series with R2. The lower input trip voltage Va1 is

defined as

(1)

When Vin is greater than Va (Vin > Va), the output voltage is low very close to ground. In this case the three

network resistors can be presented as R2//R3 in series with R1. The upper trip voltage Va2 is defined as

(2)

Submit Documentation Feedback

Product Folder Links: LMV331-N LMV339-N LMV393-N

LMV331M7X 数据表(PDF) 8 Page - Texas Instruments